Phenacyl chloride

Phenacyl chloride, also commonly known as chloroacetophenone, is a substituted acetophenone. It is a useful building block in organic chemistry. Apart from that, it has been historically used as a riot control agent, where it is designated CN.[4] It should not be confused with cyanide, another agent used in chemical warfare, which has the chemical structure CN−.

Phenacyl chloride
Names
Preferred IUPAC name
2-Chloro-1-phenylethan-1-one
Other names
2-Chloro-1-phenylethanone
α-Chloroacetophenone
2-Chloroacetophenone
Chloromethyl phenyl ketone
Phenyl chloromethyl ketone
CN
Weeping gas[1]
Mace
Identifiers
3D model (JSmol)
ChEMBL
ChemSpider
ECHA InfoCard 100.007.757
UNII
Properties
C8H7ClO
Molar mass 154.59 g·mol−1
Appearance white to gray crystalline solid[2]
Odor pungent and irritating[2]
Density 1.324 g/cm3
Melting point 54 to 56 °C (129 to 133 °F; 327 to 329 K)
Boiling point 244.5 °C (472.1 °F; 517.6 K)
insoluble
Vapor pressure 0.005 mmHg (20 °C)[2]
Hazards
Main hazards Combustible[2]
T
NFPA 704 (fire diamond)
Flammability code 1: Must be pre-heated before ignition can occur. Flash point over 93 °C (200 °F). E.g. canola oilHealth code 3: Short exposure could cause serious temporary or residual injury. E.g. chlorine gasReactivity code 0: Normally stable, even under fire exposure conditions, and is not reactive with water. E.g. liquid nitrogenSpecial hazards (white): no code
1
3
0
Flash point 88 °C (190 °F; 361 K)
Lethal dose or concentration (LD, LC):
417 mg/m3 (rat, 15 min)
600 mg/m3 (mouse, 15 min)
465 mg/m3 (rabbit, 20 min)
490 mg/m3 (guinea pig, 30 min)
159 mg/m3 (human, 20 min)
850 mg/m3 (human, 10 min)[3]
NIOSH (US health exposure limits):
PEL (Permissible)
 TWA 0.3 mg/m3 (0.05 ppm)[2]
REL (Recommended)
 TWA 0.3 mg/m3 (0.05 ppm)[2]
IDLH (Immediate danger)
 15 mg/m3[2]
Except where otherwise noted, data are given for materials in their standard state (at 25 °C [77 °F], 100 kPa).
N verify (what is YN ?)
Infobox references

Preparation

Phenacyl chloride is readily available commercially. It may be synthesized by the Friedel-Crafts acylation of benzene using chloroacetyl chloride, with an aluminium chloride catalyst:[5]

Riot control agent

It was investigated, but not used, during the First and Second World Wars.

Because of its significantly greater toxicity,[6] it has largely been supplanted by CS gas. Even though CN is still supplied to paramilitary and police forces in a small pressurized aerosol known as “Mace” or tear gas, its use is falling as pepper spray both works and disperses more quickly than CN and is less toxic than CN.

The term "Mace" came into being because it was the brand-name invented by one of the first American manufacturers of CN aerosol sprays. Subsequently, in the United States, Mace became synonymous with tear-gas sprays in the same way that Kleenex has become strongly associated with facial tissues (a phenomenon known as a genericized trademark).

Like CS gas, this compound irritates the mucous membranes (oral, nasal, conjunctival and tracheobronchial). Sometimes it can give rise to more generalized reactions such as syncope, temporary loss of balance and orientation.[6] More rarely, cutaneous irritating outbreaks have been observed and allergic contact permanent dermatitis.[4]

At high concentrations, CN may cause corneal epithelial damage and chemosis. It has also accounted for at least five deaths, which have resulted from pulmonary injury and/or asphyxia.[7]

TRPA1 (Transient Receptor Potential-Ankyrin 1) ion channel expressed on nociceptors (especially trigeminal) has been implicated as the site of action for CN, in vivo and in vitro [8][9]

gollark: ++tel help
gollark: ?tag create "dial heavserver" ++tel dial MatsWidenBacon
gollark: Heavpoot did it and I WILL NOT touch their code,
gollark: hd!histohist -1
gollark: ?tag p⁡ipi

References
  1. Verma, K.S. Cengage Physical Chemistry Part 1, Illustration 5.65
  2. NIOSH Pocket Guide to Chemical Hazards. "#0119". National Institute for Occupational Safety and Health (NIOSH).
  3. "alpha-Chloroacetophenone". Immediately Dangerous to Life and Health Concentrations (IDLH). National Institute for Occupational Safety and Health (NIOSH).
  4. Treudler, R.; Tebbe, B.; Blume-Peytavi, U.; Krasagakis, K.; Orfanos, C. E. (1999). "Occupational contact dermatitis due to 2-chloracetophenone tear gas". British Journal of Dermatology. 140 (3): 531–534. doi:10.1046/j.1365-2133.1999.02724.x. PMID 10233281.
  5. Levin, N.; Hartung, W. H. (1955). "ω-Chloroisonitrosoacetophenone". Organic Syntheses.CS1 maint: multiple names: authors list (link); Collective Volume, 3, p. 191
  6. Ballantyne, B.; Swanston, D. W. (1978). "The comparative acute mammalian toxicity of 1-chloroacetophenone (CN) and 2-chlorobenzylidene malononitrile (CS)". Archives of Toxicology. 40 (2): 75–95. doi:10.1007/BF01891962. PMID 350195.
  7. Blain, P. G. (2003). "Tear Gases and Irritant Incapacitants: 1-Chloroacetophenone, 2-Chlorobenzylidene Malononitrile and Dibenz[b,f]-1,4-Oxazepine". Toxicological Reviews. 22 (2): 103–110. doi:10.2165/00139709-200322020-00005. PMID 15071820.
  8. doi=10.1096/fj.08-117812
  9. doi=10.1016/j.taap.2008.04.005
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.