I joined a Cisco IPSEC VPN (based on Group Authentication).
I had to install the VPN using some tricks since is not working anymore on Windows 10.
The problem is that once connected in VPN internet is no working anymore.
This is my route table
IPv4…
I have two routers on VMWare workstation, Router01 and Router02, both are set up as Host Only Networks.
I need to route between the two networks, so that from Router01 I can ping the public endpoint of Router02 and vice versa ?
Private Endpoint…
I currently have the following setup whereby I need Server #1 to reach the Internet via Server #2 using its second NIC.
Is this possible using static routes? If so which route should be added to where?
At present server 1 can ping server 2, and…
I was wondering whats the best way to do a static route for all ips except a predefined set.
For example, I have 2 networks attached to one workstation. I want all ips except 192.168.0.0/24 to go through network A and all other through network B.…
I've got a VPN between two networks, one home and one office (A and B). Their subnets are: (A) 192.168.1.0 and (B) 192.168.0.0
The two networks have identical ADSL routers. Unfortunately these can only do dial-out VPN. So I've got a Windows 2008…
I am trying to get my main network to see my homelab network (separate subnets) and both networks have access to the internet. I have tried several approaches and now have 4 routers in the configuration shown below
As you can see I have attempted…
I have a Windows Hyper-V Free Edition R2 2012 server and I need to create a static route for Hyper-V to communicate with private internal addresses and vice-versa.
I tried to add the route manually, but when Windows restarts, it doesn't work (but…
I have a Windows 2003 server which is connected to a router at 192.168.15.1 via 192.168.15.10.
I also have a linux server connected to that same router via 192.168.15.90.
And I have a direct connection between those two machines via 192.168.15.11…
I see people genuinely helping out here but please stop with down-votes.I wouldn't have posted on server fault if this wasn't really a business problem.I am going to upgrade this network with a Failover WAN connection and separate the Home and Work…
I have router A connected to router B on a LAN to WAN setup.
Router A is 192.168.0.1 (subnet mask 255.255.255.0)
Router B is 192.168.1.1 (subnet mask 255.255.255.255)
I have a NAS device connected to router A with IP 192.168.0.108. How can I access…
i know the command is ip route [remote address] [next hop address] but how do i implement it?
Currently these are the only ones that are connected:
CALOOCAN - MAKATI
MAKATI - NAVOTAS
SWITCH0-PC0-PC1
SWITCH1-PC2-PC3
SWITCH2-PC4-PC5
Here's the…