Sydenham rail disaster

The Sydenham rail disaster occurred on 19 December 1953 when a New South Wales Government Railways electric passenger train travelling to Bankstown ran into the rear of another electric train travelling to East Hills at Sydenham.

Sydenham rail disaster
Details
Date	19 December 1953
Location	Sydenham, New South Wales
Country	Australia
Line	Illawarra
Operator	New South Wales Government Railways
Incident type	Collision
Cause	Wrong-side failure
Statistics
Trains	2
Deaths	5
Injured	748

Sydenham Rail Disaster 1953

Sydenham Rail Disaster 1953

Sydenham Rail Disaster 1953

Five people were killed and 748 injured.[1][2] A wrong-side failure of the signalling system, as a result of human intervention, was believed to be the cause.[3]

The crash

Two suburban passenger trains, the first travelling to East Hills the following train travelling to Bankstown, collided at about 12:30pm.[3] The Bankstown train was travelling at 30 to 35 miles per hour (48 to 56 km/h) a few seconds before the crash.[4] Both trains were crowded, each with around 1200 passengers, many travelling home after work (it being a Saturday), and Christmas shoppers.[4] The East Hills train was being held at a home signal just on the Sydney side of Sydenham Junction station. The two leading cars of the Bankstown train telescoped into the two trailing cars of the East Hills train.[5]

Synopsis

Signals behind the East Hills train should have been showing stop to protect the train, it was established that the signals were in fact showing proceed giving the following train the belief that the line ahead was clear. In the accident, a signal electrician was attending a failure of a track circuit. To help keep the trains moving, he manipulated the track circuit relay with a screwdriver.[3][6] Distracted by a telephone call, he forgot to remove the screwdriver to drop the track circuit relay when the section became occupied by a train, allowing a second train to see green signals and collide with the first.[7]

The driver of the second train (the Bankstown train) was charged with manslaughter, accused of being under the influence of alcohol.[3] He was later acquitted of the charge by a jury.[8] A Signals Electrician was also charged with manslaughter for his part in the incident.[9]

Aftermath

Since that time, training and procedures for signal electricians have been strengthened and it is clearly stated in railway rules that in the event of a track circuit failure, no attempt shall be made to clear any of the signals controlled by the track circuit by manipulation of the track circuit relay...[10]

Two carriages of the East Hills train (the second and sixth) were older wooden bodied carriages and it was claimed this may have contributed to the deaths and injuries, although the Bankstown train, a fully steel carriage train, suffered more damage.[11]

References

1. "Office for Emergency Services". New South Wales Government (Australia).
2. "Chronology of Australian train crashes". The Daily Telegraph. Australia. 6 June 2007.
3. "Driver of Train on Slaying Charge". Sydney Morning Herald Newspaper. 9 November 1954.
4. "Signals Against Train in Tragic Sydney Crash". Courier Mail Newspaper. 21 December 1953.
5. "Railwaymen Suspended: Reason not Disclosed". Courier Mail Newspaper. 22 December 1953.
6. "Screwdriver In Signal Mechanism". Morning Bulletin (29, 509). Queensland, Australia. 4 March 1954. p. 4 – via National Library of Australia.
7. "Screwdriver in Signal". The Sydney Morning Herald (36, 250). New South Wales, Australia. 26 February 1954. p. 5 – via National Library of Australia.
   "1953, December 19, Sydenham rail emergency". Emergency New South Wales. Archived from the original on 21 November 2007.
8. "Train Driver Acquitted". Cairns Post Newspaper. 12 November 1954.
9. "Railway Men For Trial". Cairns Post (16, 219). Queensland, Australia. 5 March 1954. p. 1 – via National Library of Australia.
10. "SMP04 - Clause 1.6.9". NSW Signalling Maintenance Procedures.
11. "Railwaymen Suspended". Sydney Morning Herald. 22 December 1953.