Hoppus

The hoppus cubic foot (or ‘hoppus cube’ or ‘h cu ft’) was the standard volume measurement used for timber in the British Empire and countries in the British sphere of influence before the introduction of metric units. It is still used in the hardwood trade of some countries. This volume measurement was developed to estimate what volume of a round log would be usable timber after processing, in effect attempting to ‘square’ the log and allow for waste. The hoppus ton (HT) was also a traditionally used unit of volume in British forestry. One hoppus ton is equal to 50 hoppus feet or 1.8027 cubic metres. Some shipments of tropical hardwoods, especially shipments of teak from Myanmar (Burma), are still stated in hoppus tons.[1]

For the musician, see Mark Hoppus.

History

The English surveyor Edward Hoppus introduced the eponymous unit in his 1736 manual of practical calculations. [2][3] The tables include reference to stone as well as timber, as stone can similarly suffer wastage during processing into regular pieces.

Calculation of timber volume in round logs

The following calculation can be used to estimate the usable timber in round logs using a "girth tape" that is calibrated in "quarter-girth inches" (e.g. that shows "12" when measuring a 48-inch-circumference log):[4]

Hoppus Volume (h ft) = ("Quarter Girth" (in))2 × Length (ft) / 144 = (circumference (ft) / 4)2 × Length (ft)

Equivalents:

  • 1 h ft = 1.273 ft3
  • 27.74 h ft = 1 m3
  • 1 h ft = 0.03605 m3
gollark: So, I want to read some values from an I2C device. Now, you might think "foolish gollark that's something like 50 lines of python at absolute most", and it is except to get anything but raw values I need to use some on-chip "digital motion processor" which is extremely poorly documented.
gollark: Yes, I was replying to ubq.
gollark: I'm having to edit and use 3000 lines of code I don't understand which is doing low-level sorcery to interface with some hardware.
gollark: What did you THINK horrible constant segfaults meant?
gollark: I said, even.

See also

References
  1. "Myanmar Inter Safe Co., Ltd,".
  2. "Units: H". www.unc.edu.
  3. Hoppus, Edward (14 November 2017). "Hoppus's Tables for Measuring, Or, Practical Measuring Made Easy: By a New Set of Tables ..." Longman and Company – via Google Books.
  4. "Genesis Timber Specs". www.genesisny.net.
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.