HMS Nasturtium (1915)

HMS Nasturtium was an Arabis-class sloop built in Scotland and launched in 1915.

HMS Nasturtium
History
United Kingdom
Namesake: Nasturtium
Builder: A. McMillan and Sons, Dumbarton, Scotland
Laid down: 1 July 1915
Launched: 21 December 1915
Fate: Sunk off Malta, 28 April 1916
General characteristics
Class and type: Arabis-class sloop
Displacement: 1,250 tons
Length:
  • 255 ft 3 in (77.80 m) p/p
  • 267 ft 9 in (81.61 m) o/a
Beam: 33 ft 6 in (10.21 m)
Draught: 11 ft 9 in (3.58 m)
Propulsion:
  • 1 × 4-cylinder triple expansion engine
  • 2 × cylindrical boilers
  • 1 screw
Speed: 17 knots (31 km/h; 20 mph)
Range: 2,000 nmi (3,700 km; 2,300 mi) at 15 kn (28 km/h; 17 mph) with max. 260 tons of coal
Complement: 79 men
Armament: 2 × 1 - QF 4 inch Mk IV guns, BL 4 inch Mk IX guns or QF 4.7 inch Mk IV guns and 2 × 1 - 3-pounders (47 mm) AA.

Design and construction

Nasturtium was one of 56 Arabis class sloops built for the Royal Navy during World War I. The sloops-of-war were intended for minesweeping duties in European waters.

Nasturtium had a displacement of 1,250 tons. She was 255 feet 3 inches (77.80 m) long between perpendiculars, 267 feet 9 inches (81.61 m) in length overall, had a beam of 33 feet 6 inches (10.21 m), and a draught of 11 feet 9 inches (3.58 m). The propulsion system consisted of two coal-fired cylindrical boilers supplying steam to a four-cylinder triple expansion engine, connected to a single propeller shaft. Maximum speed was 15 knots (28 km/h; 17 mph), and the ship could achieve a range of 2,000 nautical miles (3,700 km; 2,300 mi). Up to 250 tons of coal could be carried.

Nasturtium was laid down for the Royal Navy by A. McMillan and Sons, Dumbarton, Scotland on 1 July 1915 with yard number 464. She was launched on 21 December 1915.[1]

History

HMS Nasturtium was based at Malta. On 24 April 1916, she left Malta but was ordered to return immediately to search for a submarine in the vicinity. On 27 April the German submarine U-73 laid 22 mines outside the Grand Harbour of Valletta. The battleship HMS Russell sank after hitting two of these mines.

Nasturtium arrived in Malta on 27 April. The Rear Admiral of Patrols based at Fort Rinella ordered the sloop to search for mines and submarines. At 19:10 she ended up in the same minefield as the Russell and struck a mine which exploded 7 feet below the waterline on her starboard side close to the foremost funnel. Seven crew members were killed. Her boiler rooms began to flood and the tug Prompt was sent from Sliema to assist her. By 21:00, she had a heavy list and all the crew were evacuated, except for a few hands on the forecastle. By 21:38 the remaining crew abandoned the ship since she was now listing by 30 degrees to port. At 21:50 the naval yacht HMY Aegusa hit a mine in the same minefield and sank.

The Nasturtium finally sank at 02:45 on 28 April 1916. A court martial regarding her loss was held on board HMS Theseus on 8 May 1916. Her wreck now lies at a depth of 67 metres.[2]

gollark: ```03-01 21:54:43.706 492 492 F libc : Fatal signal 11 (SIGSEGV), code 1 (SEGV_MAPERR), fault addr 0x0 in tid 492 (recovery), pid 492 (recovery)03-01 21:54:43.707 494 494 F libc : failed to exec crash_dump helper: No such file or directory03-01 21:54:43.708 492 492 F libc : crash_dump helper failed to exec03-01 21:54:48.709 496 496 W libc : Unable to set property "ro.twrp.boot" to "1": error code: 0xb03-01 21:54:48.710 496 496 W libc : Unable to set property "ro.twrp.version" to "3.4.0-TEST_MRMAZAK_10": error code: 0xb03-01 21:54:48.711 496 496 F libc : Fatal signal 11 (SIGSEGV), code 1 (SEGV_MAPERR), fault addr 0x0 in tid 496 (recovery), pid 496 (recovery)03-01 21:54:48.714 498 498 F libc : failed to exec crash_dump helper: No such file or directory03-01 21:54:48.715 496 496 F libc : crash_dump helper failed to exec03-01 21:54:53.721 499 499 W libc : Unable to set property "ro.twrp.boot" to "1": error code: 0xb03-01 21:54:53.721 499 499 W libc : Unable to set property "ro.twrp.version" to "3.4.0-TEST_MRMAZAK_10": error code: 0xb03-01 21:54:53.722 499 499 F libc : Fatal signal 11 (SIGSEGV), code 1 (SEGV_MAPERR), fault addr 0x0 in tid 499 (recovery), pid 499 (recovery)03-01 21:54:53.724 501 501 F libc : failed to exec crash_dump helper: No such file or directory03-01 21:54:53.725 499 499 F libc : crash_dump helper failed to exec```It seems to log this every few times a second, how amazing!
gollark: If it comes to it I *think* I can reflash it from the "MTK scatter tool" but this would require me to find a windows computer somewhere and such.
gollark: Or fastboot.
gollark: I can get *recovery mode*, but only a somewhat broken recovery mode which lets me run shell commands somehow but which does not seem to want to actually boot into system mode, *somehow*.
gollark: I did some things a while ago, forgot about them, rebooted now, and [REDACTED].

References

This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.