Questions tagged [crossover]
9 questions
4
votes
1 answer
Solaris crossover via fiber
I have two Sun servers running Solaris 10. Both have Emulex fiber channel cards. I'd like to connect the two in a "crossover" fashion like you would copper ethernet & IPv4. Point being I have a ZFS array attached to one that I'd like to share to…
![](../../users/profiles/7033.webp)
churnd
- 3,977
- 5
- 33
- 41
1
vote
1 answer
Network latency caused by incorrect cable?
Our team recently setup a new network and now we are experiencing network latency issues. the flow of traffic is as such:
modem -> router -> packet shaper -> cisco3750 switch
from router to packet shaper, I believe we used a cross over cable and…
![](../../users/profiles/184727.webp)
nGX
- 344
- 1
- 6
- 19
1
vote
2 answers
ethernet cable is connected but It shows unplugged
I told datacenter too connect two of my servers with a crossover cable to each other. But when I try this command
ethtool eth0
Settings for eth0:
Supported ports: [ TP ]
Supported link modes: 10baseT/Half 10baseT/Full
…
![](../../users/profiles/149713.webp)
Mehdi Azizi
- 51
- 11
1
vote
1 answer
How to connect computers directly with ethernet?
I try to connect two linux computers via a crossover cable. I need help at troubleshooting.
I configured ip-address , and on PC1 ifconfig-command shows
enp0s7: flags=4163 mtu 1500
inet 192.168.0.1 netmask…
![](../../users/profiles/560701.webp)
Karl
- 11
- 1
0
votes
1 answer
Ethernet patch or crossover router to router
I we have run Ethernet in the house, through a fast Ethernet switch, through a wall patch, over the river and through the woods as it were. From router A, through switch, through wall patch, then to second router B. I read router to router, switch…
0
votes
1 answer
Ping Interconnected PCs End-To-End
I have the following network topology:
[PC 1] - - - [PC 2] - - - [PC 3] - - - [PC 4]
Each machine is connected via a crossover cable. I can ping from PC 1 to PC 2, but how can I configure things so as to ping from PC 1 all the way to PC 4?
![](../../users/profiles/95684.webp)
THE DOCTOR
- 185
- 4
- 14
0
votes
2 answers
seprate mysql server and eth0 configuration
I have bought another server for mysql. and now the webserver and the mysql server are connected with a crossover cable.
I want to configure ips manually.
On webserver eth1 is for internet. eth0 is connected to crossover cable.
how should I…
![](../../users/profiles/149713.webp)
Mehdi Azizi
- 51
- 11
0
votes
1 answer
Send email between servers using a crossover cable and postfix
I don't know where or what I should be reading about when I want to send email between two different domains as follows and please give an example basic Postfix configuration. All conditions in the list below MUST apply:
Each domain is on a…
![](../../users/profiles/311333.webp)
superlinux
- 141
- 5
0
votes
1 answer
Access mysql from another computer connected with crossover cable
I have two computers, and i am trying to access mysql via network on port 3322 (mysql listens on this port)
Computer A Server:
Windows 10 home
Added firewall exception to port 3322 (mysql installed and listens on this port)
Static IP address:…
![](../../users/profiles/79161.webp)
Smith
- 133
- 5