5

So I replaced the battery for my Dell Perc 5/i controller since the machine had an error code that it needed to be replaced. I ordered the battery directly from dell based on the service code and installed it without issue.

In open manage it still showed as an issue, so I chose the option to learn under I went in to Dell Open Manage and told it to Learn/Cycle Storage->Perc->Battery->Tasks (it was the only option).

That was approximately 1 week ago! It said it could take 72 hours, but it's still going. This is the current status:

 Battery on Controller PERC 5/i Integrated  

Name Battery 0 
State Learning 
Predicted Capacity Status Unknown 
Learn State Active 
Next Learn Time 0 hours 
Maximum Learn Delay 7 days 0 hours 
Battery Tasks No Task Available

Thanks!

Scott Szretter
  • 1,860
  • 11
  • 42
  • 66

3 Answers3

3

I replaced batterys on 4 diffrent perc 5/i controllers just a week ago. It took about 12-24 hours to show up as OK state.

Jonasss
  • 116
  • 3
2

It's possible you got a bad battery. It trickle charges most likely at a very low voltage right? So I'd expect anywhere from 24 to 36 hours, maybe less. It could simply be reading the state wrong, try a cold shutdown of the server and power it back on and see if it persists. Then call Dell and get another battery sent out.

SpacemanSpiff
  • 8,733
  • 1
  • 23
  • 35
1

It could also be the controller or it's firmware. Have had a few like that.

David
  • 74
  • 3
  • Never had a faulty controller myself, but if a second replacement battery does the same thing that would be my next suspect. – voretaq7 Sep 09 '11 at 14:14