Salzwedel–Dannenberg railway

The Salzwedel–Dannenberg railway was a branch line between Salzwedel in the north of Saxony-Anhalt and Dannenberg in eastern Lower Saxony in Germany. It was built in 1891 by the Prussian state railways, initially as a stub line from Salzwedel to Lüchow and extended in 1911 to Dannenberg. Shortly before the end of the Second World War the line between Salzwedel in the Soviet Zone and Lübbow in the British Zone was cut. Passenger services ceased in 1975, goods trains continued tor run until the end of 1997. The section still being worked between Lüchow and the station at Dannenberg Ost has been owned since 2001 by the Deutsche Regionaleisenbahn (DRE) and is called the Jeetzel Valley Railway (Jeetzeltalbahn).[1]

Salzwedel–Dannenberg railway
Lüchow station in 1983
Overview
Line number6905
Technical
Line length36.2 km (22.5 mi)
Track gauge1,435 mm (4 ft 8 1⁄2 in)
Route number
  • 117a (1914)
  • 117b (1925)
  • 117c (1930)
  • 187d (1937)
  • 186f (1939)
  • 209d (1941)
  • 109h (1950-1970)
  • 152 (1971-1975)
  • 113 (since 2005)
Route map
from Oebisfelde
0,0 Salzwedel
 20 m
Salzwedel Kleinbahnhof, from Diesdorf and Kalbe
from Wittenberge
 5.0 Bürgerholz
 19 m
 6.13
6.5 19 m
 6.7 Lübbow
 19 m
 8.9 Teplingen
 18 m
L 262
 18 m
 10.6 Wustrow (Han)
 18 m
 13.1 Jeetzel
 18 m
 15.6
Lüchow Süd, LSE aus Schmarsau
 15.7
B 248 and B 493
 19 m
 15.8 Lüchow
 20 m
 16.9 Tarmitz
 18 m
 18.3
Bridge over the Jeetzel
 16 m
 20.3 Müggenburg
 15 m
 20.4 Gollau
 24 m
 22.9 Grabow (Dannenberg)
 14 m
 26.7 Jameln (Dannenberg)
 18 m
 30.0 Tramm
 15 m
 31.1 Schaafhausen
 14 m
 18 m
 18 m
 32.8
Bridge over the Jeetzel
 15 m
from Uelzen
 33.3 Dannenberg West
 15 m
 33.5
B 216
 15 m
 34.3
Bridge over the Alte Jeetzel
 13 m
from Lüneburg
 36.2 Dannenberg Ost
 13 m
to Wittenberge
Lüchow lay between the Wittenberge–Buchholz (above) and Stendal–Langwedel lines and was linked to a stub line in 1891

Lüchow-Salzwedel (1891)
Footpath on the old railway embankment in the forest near Hoyersburg.

In the 1860s two railways were planned that would enable a direct connection between Berlin and Bremen. In both cases, a route via Lüchow was under discussion. The branch line Wittenberge-Buchenholz was built via Dannenberg, however, and then the Stendal-Langwedel line via Salzwedel. After the opening of this route in April 1873 Lüchow therefore asked to build a branch line to Salzwedel. It was 18 years before construction began on this spur track. The line from Oebisfelde to Salzwedel was the first to be built and was opened by the Prussian state railways in 1889. The construction of the branch to Lüchow began in 1891. Work over the open country progressed rapidly. Only between the subsequent halt of Bürgerholz and Lübbow did marshy terrain have to be crossed. In early March, the track to Wustrow was completed and by 22 April 1891 it had reached Lüchow. It was taken over by the state police on 28 September 1891 and opened on 1 October. The station at Lübbow could not be used immediately, because the community refused to supply the paving stones and the embankment for the link road to the station. The decision was first taken in 1892, so that the first train did not call at Lübbow until 1 May 1892, eight months after the opening of the line.

  • Salzwedel shed. In front, the America Line tracks.
  • The row of trees marks the dismantled Salzwedel–Lübbow section below the America Line, which is being worked by a goods train to Stendal.
  • The old station building in Wustrow. The tracks end behind the blue containers by the silo.
  • The old station at Dannenberg West; now a house.
gollark: Very cool. I had the vague idea of bodging Alpine Linux a bit to directly boot into a CC emulator and then PotatOS, with a few services on the host to provide the ability to execute commands and whatnot from CC, but you... actually implemented something like that, which is a lot better.
gollark: But CC has previously made a bunch of breaking changes and "deprecated" (whoever wrote that on the old wiki does not know what it means) outdated stuff.
gollark: It *does* break compatibility if `setfenv` isn't available.
gollark: You can also use `setfenv`, but I think that might go away eventually? Depends on the will of the squidly one.
gollark: `load(your_code, filename [or nil, probably], "t", environment_table)`

References

The information in this article is derived mainly from Eisenbahnzeit im Wendland. In addition the following sources are cited:

  1. Von Bahnkunden – für Bahnkunden. Selbstdarstellung. Deutsche Regionaleisenbahn, Berlin 22 February 2006, p. 9–12. (914 KB)

Sources
  • Ulrich Bornmüller, Dr. Rolf Meyer (Red.): Eisenbahnzeit im Wendland: Beiträge zur Eisenbahngeschichte des Landkreises Lüchow-Dannenberg. Hartmut Geller, Museumsverein Wustrow e.V., 1990, ISBN 3-925861-06-8
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.