4
1
I have two different routers connected to different ISPs having different LANs. I want to set up the network in such a way that we can connect to devices on the other LAN or ping devices on the other network. One router has DHCP enabled. NAT is enabled on both of the routers.
I have tried putting in a static router but I am not sure if I am doing it right. I want to connect to computers, DVR and other devices. Right now I change 0 and 1 in the IPs to switch between networks. Is there a way to do it?
Router A's settings: IP Address: 192.168.1.1 Subnet Mask: 255.255.255.0
Router B: IP Address: 192.168.0.1 Subnet Mask: 255.255.255.0
(192.168.1.1) (192.168.0.1)
WAN 1> Router A> Switch1-----------Switch2< Router B(DHCP) < Wan 2
| |
Computers and Printer Computers, IP Phones and DVR
If you have a layer 3 switch in your network at all, you can avoid needing a new router by just plugging the two routers into it and configuring separate vlans, along with vlan interfaces, for the separate LAN's. Use the same method as given above to set the routing tables up on router A and B. This is less likely to be the best solution for you, hence it being in a comment, but is thrown in for completeness. – 0xDAFACADE – 2014-08-13T23:15:24.640
1I used Cisco 851 to do this. Configured one ip on the WAN side and another on VLan1 cuz this router is a hybrid router and has Ethernet ports in switch mode. Plugged the router in the network and added static routes and it worked! Thanks for your help – Kunwar – 2014-08-27T00:35:32.077