2
When I plug in a Category 5 cable to get an Ethernet connection, the system detects a wired connection. However, I cannot access the Internet.
When I choose to connect to the wired connection, the display that shows the WiFi connection is just a loading bar. I have been trying to figure this out for days.
Here is some information:
root@kali:~# iwconfig
wlan0 IEEE 802.11 ESSID:"CenturyLink9642"
Mode:Managed Frequency:2.462 GHz Access Point: E8:37:7A:C8:2F:27
Bit Rate=72.2 Mb/s Tx-Power=10 dBm
Retry short limit:7 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:on
Link Quality=70/70 Signal level=-23 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:476 Missed beacon:0
wlan0mon IEEE 802.11 Mode:Monitor Tx-Power=0 dBm
Retry short limit:7 RTS thr:off Fragment thr:off
Power Management:on
eth0 no wireless extensions.
lo no wireless extensions.
root@kali:~# iwconfig eth0
eth0 no wireless extensions.
root@kali:~# sudo ethtool -i eth0
driver: r8169
version:
firmware-version: rtl8168g-2_0.0.1 02/06/13
expansion-rom-version:
bus-info: 0000:08:00.0
supports-statistics: yes
supports-test: no
supports-eeprom-access: no
supports-register-dump: yes
supports-priv-flags: no
root@kali:~#