0
I have installed openSUSE Leap as dual boot. I want to have feature Wake on LAN. When I check in windows "Enable wake on magic packet only" and turn off, it works. When I boot to opensuse and turn the computer off, it does not work.
So I think the problem is not in delivery of this packet but in target network card settings.
I tried:
# ethtool eth0
Settings for eth0:
Supported ports: [ TP ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Supported pause frame use: Symmetric Receive-only
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Advertised pause frame use: Symmetric
Advertised auto-negotiation: Yes
Speed: 100Mb/s
Duplex: Full
Port: Twisted Pair
PHYAD: 0
Transceiver: internal
Auto-negotiation: on
MDI-X: Unknown
Current message level: 0x000060e4 (24804)
link ifup rx_err tx_err hw wol
Link detected: yes
Is it the problem of driver? Is it overridable somehow?
When I boot to opensuse and turn it off, it does not work. Are you expecting wake-on-LAN to work after you've turned it off? Have you tried turning wake-on-LAN on using
ethtool
? – Andrew Henle – 2018-05-06T15:08:51.897I mean "when I turn off the computer and nothing manually changing". yes, I tried but:
# ethtool -s eth0 wol g Cannot get current wake-on-lan settings: Operation not supported not setting wol
– DonPaulie – 2018-05-06T15:38:51.3101This is a function of the hardware and BIOS, not the OS. Have you checked in the BIOS for wake on lan settings? “Turning off” and putting it in to “standby” are two different things. – Appleoddity – 2018-05-06T17:37:37.850