Questions tagged [veritas]

23 questions
1
vote
0 answers

Veritas Cluster nodes reboot when another is reset or hard turned off

We are conducting bi-yearly resiliency test on a 4 node VCS cluster. With two applications running on nodes 1-3 and 2-4 resp. in active-standby mode. When making a manual switch over, or a graceful shutdown on one node, application will nicely…
nmajoros
  • 111
  • 1
1
vote
0 answers

Is it possible to backup and restore a Netbackup Master server using Windows Server Backup?

I have installed Netbackup 8.2 master server on Windows Server 2019 system. I read this document , which says you neet to re-install OS and Netbackup itself, then the catalog in order to restore NetBackup Master Server. I wonder if its possible to…
0
votes
1 answer

Ensure Puppet performs procedural steps as part of deployment

I know using procedural steps in Puppet is generally frowned upon, but since we are using it to deploy Veritas-managed clustered applications, there is a specific set of steps that must happen before the rpm install is called. Currently, we manually…
bdetweiler
  • 137
  • 5
0
votes
2 answers

VxFS on both Solaris and RHEL?

I'd like to know if VxFS could be used in order to share a volume ( on a SAN mounted using FC) between a RHEL (5 or 6) and Solaris (11) host ? What I'm trying to achive is to shared a volume (from a SAN) across a grid of hosts running Solaris and…
devlearn
  • 141
  • 1
  • 6
0
votes
1 answer

remove path from VxDMP

Due to some temporary parallel cabling, VxVM 5.0 began to use two paths to a 3510 disk array: # vxdmpadm getsubpaths NAME STATE[A] PATH-TYPE[M] DMPNODENAME ENCLR-NAME CTLR …
asdmin
  • 2,020
  • 16
  • 28
0
votes
1 answer

Veritas cluster 5.0 mp3 failover policies

Dear ServerFault users i've got a question here. My setup is following: Two node cluster, one service group which consists of 4 tiers of resources. Group is activated and probed on both nodes and basically it failovers normally. But i need one…
0
votes
3 answers

Lost P/W Tape Backup

We need to perform complete restore to critical server using tape backup (Veritas). Found out that former IT director put p/w on tape and we cannot locate or figure it out. Options for recovery?
Jeff Rawlins
0
votes
2 answers

BackupExec - write a yearly backup to multiple tapes in a library?

I have BackupExec 12.5. I have about 25 servers that need to be backed up to tape. I already have the tape library "partitioned" into the 12 tape slots for normal backups, so it isn't just a single large partition. I'd like to backup these 25…
TheCleaner
  • 32,352
  • 26
  • 126
  • 188
1
2