I'm just starting out with my unifi gateway and I was configuring a firewall rule through the UI. I messed up creating a "IPV4 Address Group". It has the wrong IP address ranges and I'm stuck. I have found no way of editing or deleting a "IPV4 Address Group" in the UI. I'm assuming it might be possible if I were to SSH into the gateway. I'm able to SSH in, but haven't found appropriate documation of how to configure the unifi gateway via command line.
Asked
Active
Viewed 3,162 times
1 Answers
3
Using your Unifi network controller, you can go into the Routing & Firewall of your Settings tab, select Firewall, click on the Groups tab, then just delete the appropriate entry group.
![](../../users/profiles/553784.webp)
user2812729
- 46
- 2
-
A screenshot is helpful because it is possible O.P. is using the webserver embedded in the gateway and not a controller. If so, a screenshot of the controller would open a whole new world to O.P. – rjt Dec 30 '19 at 01:06
-
this was the correct solution for me. i completely missed the groups tab. thanks – pgreen2 Jan 04 '20 at 16:01