I have a question about MTU or path MTU. In my setup I have 2 computers (firewall, Windows PC) and one NAS, each with a gigabit interface. They are connected throughout the same gigabit switch. In all of them I configured a MTU of 9000. Also activated "Jumbo Packets" on the interface of the Windows PC.
After measuring the path MTU with nmap I received a weird result:
- When I messure from the NAS to the firewall and to the PC the result is 9000.
- When I messure from the firewall to the PC and to the NAS the result is 9000.
BUT
- When I messure from the PC (Windows firewall on and off) to the firewall and to the NAS the result is 1492.
Do you have an explanation for these weird behavoir?
Asked
Active
Viewed 71 times
0
Hirsch
- 1
- 2
-
1492 is the default value for windows and ethernet on windows – djdomi Sep 13 '19 at 21:26
-
Ok, but I edited the MTU value of my ethernet interface and windows shows me this value in the status of the interface. – Hirsch Sep 13 '19 at 22:26
-
With "netsh interface ipv4 show interfaces" Windows shows me the 9000. – Hirsch Sep 14 '19 at 10:28
-
i think some device is not ablr to handle jumbo frames, even yozr switch must hsvr the ability to use them – djdomi Sep 14 '19 at 11:07
-
It sounds like your PC NIC can't do jumbo frames -- even tho the software says it can. – Ron Trunk Sep 14 '19 at 15:23
-
I think that`s not the case. My NIC is an "Intel(R) Ethernet Connection (2) I219-V" and it is suitable for jumo frames (https://ark.intel.com/content/www/us/en/ark/products/82186/intel-ethernet-connection-i219-v.html). – Hirsch Sep 15 '19 at 22:29