While setting up ISP Redundancy on a Check Point cluster I ran into an issue preventing me from proceeding with my configuration. I was eventually able to resolve this and felt that I would share with you and my future self the steps taken.
What is ISP Redundancy
ISP Redundancy enables reliable Internet connectivity by allowing a single or clustered Check Point Security Gateway to connect to the Internet via redundant Internet service provider (ISP) connections. If both links are active, connections pass through one link, or both links, depending on the operating mode. If one of the link fails, new connections are handled by the second link.
Configuration Steps
Open the network object properties of the Security Gateway or cluster. Click Other > ISP Redundancy. Select Support ISP Redundancy. Select Load Sharing or Primary/Backup. Configure Links – Primary and Backup Connections Set tacking mode for Link failure and recovery Click OK — This is when I encounter my error
Error: Check Point SmartDashboard
At least one of your ISP Links lack a next hop IP Address configuration. Note: next hop IP Address is also used to automatically monitor the ISP Link^s availability.
Error: Check Point SmartDashboard
ISP Redundancy configuration on clusters requires that the interfaces which lead to your ISPs, have the same names as the corresponding physical interfaces on the cluster^s members.
