0

I accidently connected our new servers with our 10g switches using Cat5e S/FTP instead of Cat6a. Cablelength is 1 meter. There is a failover cluster running on the servers, without any traffic though (new gear). Is it enough to fix this in a couple of days or should i do it basically right now since the cluster could break due to network problems?

Rikuto
  • 183
  • 2
  • 8

1 Answers1

3

Take a look and see if there are any errors accruing on the switch ports or the server's NIC ports - ideally before/after an extended session sending a lot of traffic in both directions. If the counters are staying clean then it will probably be OK for a few days but it's something that's so cheap and easy to fix that there's no reason to leave it in place any longer than you have to.

rnxrx
  • 8,103
  • 3
  • 20
  • 30
  • Good common-sense answer. [Cables cost $2](http://www.provantage.com/tripp-lite-n201-001-bl~7TRPA1QU.htm). Replace the cables at your leisure. – ewwhite Dec 14 '16 at 03:32