We are using Windows server 2012. I have to disable RDP over internet. But Remote desktop should be used in Intranet.Is there any way to disable? Note: We are also using Sonicwall firewall.
Asked
Active
Viewed 3,496 times
-3
-
I hope you're not the admin.. – maxxvw May 31 '16 at 15:09
2 Answers
1
Then the obvious answer is to disable outside access to your RDP port (typically 3389).
This question is a bit surprising since the only ways it could be reached from the outside would be if the server was directly connected to the Internet (not firewalled), or if you had previously set a port forwarding rule in your firewall configuration.
![](../../users/profiles/284485.webp)
Julie Pelletier
- 1,000
- 6
- 8
-
Thanks for your Answer. Can you explain the steps for to disable outside access to RDP port? – Avinash May 31 '16 at 05:42
-
This site is for systems and network administrators and therefore expects its users to know these basic operations. That said, I've found you their instructions to block a port: https://support.software.dell.com/kb/sw8110 – Julie Pelletier May 31 '16 at 05:55
-
But as I mentioned in my answer, it is not normal that you'd have to block that port unless you opened it in the first place. You should therefore consult with your network administrator. – Julie Pelletier May 31 '16 at 05:55
-
Do you have a firewall between your host and your public IP address space? – Citizen May 31 '16 at 07:57
0
I agree with everyone else that if you aren't allowing traffic to the server through your firewall there is nothing to worry about.
If you want to use Windows Firewall to block it though you can create a new Inbound Rule (the default will block Edge Traversal), allow port 3389, and from there you can limit the external and internal subnets that are able to connect on that port.
![](../../users/profiles/357242.webp)
Skyler Kincaid
- 141
- 4