3

When I turn on my machine, the display is not throwing any output to it.

The fans are running fine.

The LED lights indicate no error, ' Only two LED's are blinking "Mini-BMCheartbeat LED" and "Standby power LED" The article mentions about the error LED's

http://www.manualslib.com/manual/419746/Ibm-436854u-System-X3200-M2-5u-Mini-Tower-Server.html?page=170

There are three jumpers(jp1,jp3,jp6) which are in the default locations

http://www.manualslib.com/manual/419746/Ibm-436854u-System-X3200-M2-5u-Mini-Tower-Server.html?page=31

Further analysis showed me that, I have blowed the Motherboard BIOS, it needs to be re-flashed with new bios

Could anyone please assist me in fixing this and let me know if more information is required.

Thanks, Teja

mightyteja
  • 431
  • 3
  • 13

1 Answers1

1

Recovering from a BIOS update failure:

If power to the server is interrupted while BIOS code is being updated, the server might not restart correctly or might not display video.

If this happens, use the procedure in this section to recover the BIOS code.

To complete the procedures in this section, you must make the following preparations: Download the BIOS code image to create the POST/BIOS recovery diskette, CD, or DVD from http://www.ibm.com/systems/support/.

https://www-947.ibm.com/support/entry/portal/docdisplay?lndocid=migr-5073476#DOCPRODUCTS

To create and use a diskette, you must attach an optional external USB diskette drive to the server. To enable the USB diskette drive, complete the following steps:

  1. Enable the USB Support option in the Devices and I/O Ports menu in the Configuration/Setup Utility program.
  2. Set your removable media device as the first startup device.
  3. Select the removable media device that you want to boot from and move it to the top of the list.

To recover the BIOS code, complete the following steps:

1.) Turn off the server and all attached devices; then, disconnect all power cords and external cables.

2.) Locate the boot block recovery jumper (JP6) on the system board and remove any adapters that impede access to the jumper

3.) Move the boot block recovery jumper to pins 2 and

4.) Insert the update diskette, CD, or DVD into the diskette, CD, or DVD drive

5.) Turn on the server and the monitor. After the update session is completed, remove the diskette, CD, or DVD from the drive and turn off the server

6.) Disconnect all power cords and external cables

7.) Return the boot block recovery jumper to pins 1 and 2.

8.) Reconnect the external cables and power cords; then, turn on the attached devices and turn on the server

Thank you..

mightyteja
  • 431
  • 3
  • 13