2

I'm running a SmartOS-based ZFS NAS, with a bunch of SATA disks directly connected to the logic board (no fancy disk controller / backplane or anything).

A 1.5 TB disk in my zpool recently failed. iostat says:

# iostat -En c2t5d0
c2t5d0           Soft Errors: 0 Hard Errors: 8 Transport Errors: 21 
Vendor: ATA      Product: ST31500341AS     Revision: SD17 Serial No: [...]
Size: 1500.30GB <1500301910016 bytes>
Media Error: 0 Device Not Ready: 0 No Device: 0 Recoverable: 0 
Illegal Request: 89040 Predictive Failure Analysis: 0

I hotswapped the disk with a new 2.0 TB disk, yet iostat still says the same thing — Size: 1500.30GB.

How can I tell the system to rescan the disk so it identifies the correct disk size? (I'd like it to probe the correct size so I can eventually expand my zpool.)

Already tried

  1. devfsadm -c disk as suggested on a similar question — no effect.
  2. cfgadm -c configure sata0/5::dsk/c2t5d0 — it just says Device already configured; no effect.
Community
  • 1
smokris
  • 685
  • 3
  • 13
  • 27

1 Answers1

3

You need to first initiate devfsadm cleanup subroutines.

# devfsadm -C -c disk -v

Then, configure and create device path

# devfsadm -c disk -v

If that is unsuccessful, then...

Remove the disk.

# cfgadm -c unconfigure sata0/5::dsk/c2t5d0

Initiate devfsadm cleanup subroutines.

# devfsadm -C -c disk -v

Verify the disk has been removed.

# cfgadm -al
# ls -ld /dev/dsk/c2t5d0*

Configure and create device paths

# devfsadm -c -v
# cfgadm -c configure sata0/5::dsk/c2t5d0

Verify the disk 

# cfgadm -al
# ls -ld /dev/dsk/c2t5d0*
s4v0
  • 31
  • 2