So I have an iPad that has a IPSec VPN created. I am able to connect from the outside fine and I can access my local LAN files just fine. When I connect with the Cisco AnyConnect client from the same device, it allows me to login but I can't access any LAN resources at all, or any external resources either until I disconnect the AnyConnect VPN connection. Can anyone help me understand where I need to look on the ASA to correct this, or have any ideas? Thanks!
Asked
Active
Viewed 327 times
4
-
2Are they using the same or different IP pools? How about you post some configuration snippets? – SpacemanSpiff May 08 '13 at 19:39
-
I guess that's part of my issue, I'm not sure where to set the IP pools for the different methods of connecting. I do know when I connect via anyconnect I'm getting an IP address from my local subnet that I didn't specify in the IP pool that I do pull from when connecting to the IPSec, here is my messy setup: – Richard May 08 '13 at 20:09
-
here is my messy setup: http://jajuka.net/files/config.txt – Richard May 08 '13 at 20:24
-
When you use Anyconnect, are you referencing the same group as when you use the IPSec connection? – SpacemanSpiff May 09 '13 at 06:16
-
Do anyconenct clients get IPs from the defined pool?10.2.12.151-10.2.12.250. can you see any log messages from the firewall while the users are connected to the anyconnect VPN? – GerryEgan May 09 '13 at 11:52
-
Gerry, No for whatever reason it doesn't give them an IP from the pool created, it gives them a normal DHCP lease from the local LAN, though I can't see where I set that up in the config – Richard May 09 '13 at 17:32
-
SpacemanSpiff, Yes I'm referencing the same group for both, honestly I didnt know there was a difference, I'm coming from a Sonicwall SSLVPN/NSA world hehe, should I create a new group and if so where in the config? I'm using the ASDM but could use the terminal if needed – Richard May 09 '13 at 17:33
-
Richard, do you still need help or is this resolved? – user5870571 Aug 14 '16 at 16:06