6

I need to install new SFP's in a location; however, I need them to connect to existing switches and I'm not sure what SFP type they are. All I know is I've got MM Fiber.

If I installed Cisco GLC-SX-MM 1000Base SFP's, would that cause an issue if the other end of that fiber was connected to a 100Base SFP, or do I need to have matching speeds on both ends?

Mike Pennington
  • 8,266
  • 9
  • 41
  • 86
Ryan
  • 61
  • 1
  • 2

3 Answers3

7

If I installed Cisco GLC-SX-MM 1000Base SFP's, would that cause an issue if the other end of that fiber was connected to a 100Base SFP? Or do I need to have matching speeds on both ends?

Your speeds must match

Mike Pennington
  • 8,266
  • 9
  • 41
  • 86
  • Ryan, theoretically you can have autonegotiation on fiber media. Practically speaking, I have not seen a vendor do this recently. Pluggable optics (GBICs / SFPs) make it too easy to swap the Tx speed without integrating PHY/optics autoneg support (which would require additional vendor test efforts). Copper media routinely supports autonegotiation – Mike Pennington Jul 18 '12 at 17:22
2

There are some handy links in this other serverfault question which might help.

How compatible are sfp's really?

Community
  • 1
user141655
  • 23
  • 3
0

It depends on what you mean by cause an issue. It won't break anything but you won't get a link either. They must be the same. SFPs are hot-swappable so you can remove it to inspect the label without damaging it. Additionally, you can do a show interface status to have the switch tell you the model SFP that is installed in a port.

Not only can you not mix speeds but you should stay away from mixing sfp models as well.

Paul Ackerman
  • 2,729
  • 15
  • 23
  • Thanks for the response Mike and Paul. What I meant by an issue was "will it not work". So I'll need to find out the speed / model next time I'm at site. I appreciate the help. – Ryan Jul 18 '12 at 14:11