I've just been doing some regular maintenance on my Solaris 11 box. I issued a pkg update command to be told that I needed to update pkg. This I did, and rebooted into solaris-1.
I then issued another pkg update, and it downloaded and installed about 600MB worth of packages. However, on rebooting into solaris-2, it fails to boot stating:
SunOS Release 5.11 Version 11.0 64-bit
Copyright (c) 1983, 2011, Oracle and/or its affiliates. All rights reserved.
NMI received
WARNING: intel_iommu0: generated a fault event when translating DMA read
on address 0x40000 for PCI(9, 0, 0), the reason is:
The Read field in a page-table entry is Clear when DMA read
WARNING: cpqary30: domid 3 pte: 0(paddr 0)
WARNING: CPQary3 : Smart Array P212 Controller HBA firmware Locked !!!
WARNING: CPQary3 :Please reboot the system
It then coredumps and reboots.
I've tried adding intel-iommu=no to the existing grub -B arguments, to read:
-B intel-iommu=no,$ZFS-ARGS
but, this doesn't make any difference.
Hardware is an HP X1600 with a Smart Array P212 controller.
What's going on?
scanpci -v shows PCI(9,0,0) as:
pci bus 0x0009 cardnum 0x00 function 0x00: vendor 0x103c device 0x323a
Hewlett-Packard Company Smart Array G6 controllers
CardVendor 0x103c card 0x3241 (Hewlett-Packard Company, Smart Array P212)
STATUS 0x0010 COMMAND 0x0047
CLASS 0x01 0x04 0x00 REVISION 0x01
BIST 0x00 HEADER 0x00 LATENCY 0x00 CACHE 0x10
BASE0 0xfbc00000 SIZE 4194304 MEM
BASE2 0xfbbf0000 SIZE 4096 MEM
BASE4 0x00005000 SIZE 256 I/O
BASEROM 0x00000000 addr 0x00000000
MAX_LAT 0x00 MIN_GNT 0x00 INT_PIN 0x01 INT_LINE 0x05
