i have two vlans configured into a juniper netscreen (a screenOS device). I have connected a catalyst to the nic i have configured the vlans on. I need an example configuration to shoot into the cisco to be able to ping both juniper vlan addresses from the cisco
Asked
Active
Viewed 370 times
1 Answers
0
the juniper carry two vlans on one physical port, which then the catalyst is connected to?
If so: make sure the port on the catalyst is a trunk port (and then configure another port on the cisco with either of the vlans and try to ping the netscreen from there).
3molo
- 4,340
- 5
- 30
- 46
-
You can simply create an int vlan ip address and ping from the catalyst after the trunk port is configured. – voodooo Jan 26 '11 at 14:00
-
Given it's a L3. Seems 3550 series are all L3, is that correct? – 3molo Jan 26 '11 at 14:02