iPad 2 Wi-Fi EMC 2415 LCD Replacement

Written By: Andrew Bookholt

Difficulty

Moderate

Steps

Time Required

No estimate

Introduction

Moving LCD out of the way to remove random internal components. Internal Prerequisite.

It would be good to see how reassembling.

Yes, or at least show where the adhesive parts go

There is a separate guide for this:

I'll second the request to see how to reassemble!

use the same way in reverse mode!!

The front panel ribbon cables are connected beneath the LCD. To access them, you'll need to temporarily flip the LCD over and out of the way.
Be very careful when moving the LCD, and do not attempt to remove it from the iPad—its display data cable will remain connected while it is rotated over.
Lift the LCD from its long edge closest to the volume buttons and gently flip it out of the rear case—like turning the page in a book.
Set the LCD face down on the front panel.

Conclusion

To reassemble your device, follow these instructions in reverse order.

585795 Reputation