iPad 2 GSM Headphone Jack & SIM Slot Replacement

Written By: Andrew Optimus Goldheart
  • Comments: 0
iPad 2 GSM Headphone Jack & SIM Slot Replacement

Difficulty

Moderate

Steps

8

Time Required

No estimate

Introduction

Internal prereq removal with front panel already removed.

  1. nEAx5RRXbSsLyVZM
    nEAx5RRXbSsLyVZM
    hUVgdrIlVB5tJ1dN

    • Use the edge of a plastic opening tool to flip up the retaining flap on the headphone jack and front camera cable ZIF socket.

    • Be sure you are prying upward on the hinged retaining flap, not the socket itself.

    • Peel the headphone jack and front camera cable off the rear case.

  2. Hh2iOHHLk1S4AxBW

    • Pull the headphone jack and front camera ribbon cable straight out of its socket on the logic board.

  3. Q1rEgbTcnnppKuQM

    • Remove the three 2 mm Phillips screws securing the SIM card slot to the rear panel.

  4. l4cElHcfeTCFuTiB

    • Remove the two 2.9 mm Phillips screws securing the headphone jack to the top edge of the rear panel.

  5. ySr6rQNDKbYBtuCc

    • Use a plastic opening tool to help pull the headphone jack out of its recess in the top of the rear panel.

    • Don't try to remove the assembly just yet, the ribbon cables are still connected.

  6. MTjNT1avS4TGlQSI

    • Peel the front camera and microphone cables off the rear panel.

  7. HDMcCSr23g1tvU1q
    HDMcCSr23g1tvU1q
    DUYaSFGLKiJRUeYP

    • Carefully remove the strip of tape covering the front camera cable connector.

    • Use a plastic opening tool to disconnect the front camera cable from the microphone cable immediately below it.

  8. LJrm1NotlhwB2Hjp

    • Peel the front camera cable off the microphone cable.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Andrew Optimus Goldheart

Member since: 17/10/09

502341 Reputation

0 comments