Shark ION Robot 750 Motor Replacement

Written By: corieon downing
  • Comments: 0
Shark ION Robot 750 Motor Replacement

Difficulty

Moderate

Steps

7

Time Required

30 minutes

Introduction

Your SHARK ION Robot Vacuum 750 has a nice and clean main brush, yet fails to clean the dirt along the way. You notice that the brush doesn't rotate appropriately. This malfunction may be due to the damage to the main brush motor inside. The tools requisite for this operation include a TORX T6 Screwdriver, a TORX T15 Screwdriver, and a Flathead #4 Screwdriver. You may want to check out our Outer Shell Replacement Guide to open up the internal parts.

  1. AUxfZJ2QcoDPmhyy
    AUxfZJ2QcoDPmhyy
    pdihpNkIQ4jcBo3g
    NFM3BlKcOKGLpaHl

    • Make sure the device is completely powered off before working.

    • Flip over the vacuum on a flat and uncluttered service with the bottom facing upwards.

    • Remove all seven Torx T15 screws from the device’s front bumper.

    • Remove the nine Torx T6 bolts from outer shell.

  2. W2gFc1pAZHdLmPb6
    W2gFc1pAZHdLmPb6
    YQxWBKOdTdUYei5f

    • Slightly pull front bumper to expose internal wiring.

    • Unplug the device’s front bumper wiring and completely remove front bumper.

  3. rRbKQRoGCDc4erBa
    rRbKQRoGCDc4erBa
    noT1623H2rqiZ6AZ

    • Remove the four Torx T6 bolts on the yellow brush frame.

    • Gently depress the two tabs on the frame, then lift the frame to remove it.

  4. AoAxG6SBqrsnufjG
    AoAxG6SBqrsnufjG
    FVVPTPjELr1VTLcG

    • Pick up the brush and remove it from the vacuum.

    • Push the brush to your right and lift it.

  5. ZG1eEe1XLFsGREHL
    ZG1eEe1XLFsGREHL
    UkwYUHUiO1qXvZXq
    lXI4X3fSKpWHCxXm

    • Press and hold the dust bin removal button to slide out the dust bin.

  6. HcIKhSSPKpghVSVY

    • Lift the outer shell to expose the Shark’s interior.

  7. aJMHJHBQbO6O5NNH
    aJMHJHBQbO6O5NNH
    m3Ag3dqEfZxNMek5

    • Be sure to disconnect any source of power related to your vacuum for safety purposes.

    • Remove the bolt to detach the motor by using the Phillips #0 screwdriver.

    • The motor is connected to the motherboard by this group of wires. Gently pull on the white plug to disconnect the wires.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

corieon downing

Member since: 13/09/23

181 Reputation

0 comments