Introduction

This guide shows how to remove the side panel from the camera, how to remove the back panel, and how to replace the lens.

  1. XyRHeHJxnwPRleEy
    • Slide the battery eject button open to release the battery door.

  2. Ea3Ef2khOWbPZiJD
    • With the battery door open, carefully remove all four 5 mm Phillips #1 screws.

  3. GCCxAR3arAcRJbYL
    • Rotate the camera so that the underside is facing up.

    • Remove the four 5 mm Phillips #1 screws.

  4. BTKFTPjpSFd2M4dp
    • Place the camera on a flat surface, with its underside facing you.

    • Gently pull up on the side panel to remove it from the camera.

  5. KENKDaGJ3Vo5UZn4
    KENKDaGJ3Vo5UZn4
    mIkXCnMJTnBLmdSB
    • Remove the three 4 mm Phillips #1 screws holding the weight.

    • Remove the weight.

  6. KYpMBV1HtXWZ1kds
    • Remove the two 4 mm Phillips #1 screws holding the back panel in place.

  7. uVXPrHfn3vWcwEJj
    • Apply pressure to the back panel (away from the camera) to remove.

  8. xqpGaaFkuXMfjhHn
    • Set aside back panel for now.

    • Remove the final 4 mm Phillips #1 screw holding the screen in place. It is very small and hard to see.

  9. kMjw5VmoatfnSFGP
    • Carefully apply pressure, away from the camera, to the screen to detach it from the body.

    • The white cord should still be connected to the body.

    • OPTIONAL: Remove the screen to make accessing the lens easier

  10. LNd3mCo1CJppRWyQ
    • Unscrew the two 4 mm Phillips #1 screws holding onto the lens casing

    • There are also two 4 mm Phillips #1 screws on the other side holding onto the lens casing, remove them as well.

  11. MTyVpOBp5GIvvqrv
    • Pull forward on the lens casing to remove it. The cord connecting the light to the motherboard should still be attached.

  12. H5H6qhoK56RCPssB
    • Unscrew the three 4 mm Phillips #1 screws holding the plastic lens holder.

  13. 2FFboPJTgt615MIt
    • Remove the plastic lens holder.

  14. 6ZCACwSPQX2iFJVa
    • Push the lens out of the plastic casing from the back.

    • Insert new lens into the plastic casing.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Justin Tew

Member since: 31/03/16

767 Reputation

0 comments