Introduction
If your ORFELD EV-660 has stopped charging entirely or rapidly starts and stops charging, your charging port is most likely the culprit.
-
-
Place the vacuum on its side, with the screws facing towards you.
-
Remove the 11.5 mm screws using a Phillips #1 screwdriver.
-
-
-
Using tweezers, remove the sticker connecting the two halves.
-
Use the opening pick to gently separate the top half and the bottom half of the vacuum.
-
Press the blue buttons near the sides of the battery LEDs to remove the top half.
-
-
-
Lift the battery slightly to reveal the pin connectors.
-
Gently remove the four-pin connector connecting the charging port.
-
Conclusion
To reassemble your device, follow these instructions in reverse order.
