HP 15-dy Back Cover Replacement

Written By: Spencer Day

Comments: 2

Difficulty

Moderate

Steps

Time Required

10 - 20 minutes

Introduction

Use this guide to replace the back cover on your HP 15 Laptop PC.

Note: This procedure was written using a model 15-dy2702dx HP 15 Laptop PC, but is fully compatible with any HP 15 Laptop PC whose model number starts with 15-dy or 15-ef.

Tools

Step 1

Fully shut down your laptop and unplug all cables.

Step 2

Flip your laptop over so the rubber feet are facing up.

Step 3

The rubber feet cover a total of six back cover screws.
Use an opening pick to peel up an end of the front rubber foot until you can grip it with your fingers.
Make sure both the foot and its adhesive peel up together, as they need to be removed as one piece.

Step 4

Peel the front foot away from the back cover and remove it.

Step 5

Use an opening pick to peel up an end of the rear rubber foot until you can grip it with your fingers.
Peel the rear foot away from the back cover and remove it.

Step 6

Note that the rubber feet are different:
The rear foot is thicker, with a deeper recess.
The front foot is thinner, with a shallower recess.
During reassembly:
If you're reusing the rubber feet, the leftover adhesive should be tacky enough to reuse.
If the leftover adhesive isn't sticky enough or your replacement feet didn't come with adhesive, you can use double-sided tape such as Tesa Tape to secure the feet.
Make sure the strips of tape aren't wider than 6 mm, otherwise they may not fit.
To install a foot, remove its adhesive liner, lay the foot into its matching recess, and press down firmly along the entire length of the foot to secure it.

The place in the rear is deeper than the front!

Kevin “Caoimhín” Cotham -

Thank you for the comment, the guide has been updated!

Spencer Day -

Step 7

Use a Phillips screwdriver to remove the eight screws securing the back cover:
Six 6.5 mm-long silver screws
Two 6.7 mm-long black screws
Despite the standards, Phillips screwdrivers can vary in size and shape—two drivers labeled as the same size may fit differently in the same screw. Use the size that fits the most snug into the screw head to avoid stripping it.

Step 8

Flip your laptop over and open the screen.

Step 9

Plastic clips secure the back cover to the frame. You'll hear and feel the clips release as you work.
Insert the flat side of an opening pick into the seam between the top left edge of the back cover and the frame.
Slide the opening pick down to the bottom left corner to release the clips on the left edge.

Step 10

Insert the flat side of an opening pick into the seam between the top right edge of the back cover and the frame.
Slide the opening pick down to the bottom right corner to release the clips on the right edge.

Step 11

Insert the flat side of an opening pick between the bottom right corner of the back cover and frame.
Slide the opening pick to the bottom left corner to release the remaining clips.