Introduction

This guide is a prerequisite to removing the rear case and the SD board.

  1. l6qvHbllaThS3WeQ
    • Remove the two 5.8 mm Phillips #00 screws securing the SD board cover to the rear case.

  2. PRlQt3SFyTiblNGn
    PRlQt3SFyTiblNGn
    BBXFAjcpYlILJQ5j
    2OyxXIKy1JTQOPoE
    • Turn the rear case over so that the SD card slot is facing you.

    • Use the tip of a spudger to push the bottom of the SD board cover up and out of the rear case.

    • Turn the rear case back over.

    • Lift the SD board cover out of the rear case with the tip of a spudger and remove it.

  3. vMVfNvPACoNaRJMh
    vMVfNvPACoNaRJMh
    MI11Oj4sBODURSVD
    • Grasp the SD board ribbon cable gently and pull the SD board out of the rear case.

Conclusion

To reassemble your device, follow these instructions in reverse order.

David Hodson

Member since: 14/04/10

150358 Reputation

0 comments