Introduction
Use this guide to replace the webcam, aka "webcam module," in your Framework 16" laptop.
-
-
Slide your fingernail under the inside edge of either bottom corner of the bezel.
-
Pull the bezel away from the screen to release the first few magnets.
-
-
-
Lift the bezel around the perimeter of the screen until all of its magnets are released.
-
Remove the bezel.
-
-
-
Use the flat end of a spudger, or a clean fingernail, to lift up the locking tab on the webcam module ZIF connector.
-
-
-
Use tweezers, or your fingers, to remove the two metal brackets on both ends of the webcam module.
-
-
-
Use tweezers to lift the right side of the webcam module until the cable slides out of the ZIF connector.
-
Remove the webcam module.
-
-
-
Use tweezers to gently bend the webcam cable away from the screen frame.
-
Use your other hand to align the webcam module over the cable and lower it into place.
-
Make sure the webcam module sits level with the display before flipping down the cable locking tab and continuing reassembly.
-
To reassemble your device, follow these instructions in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers Community for help.
