Fairphone 1 Midframe Assembly Replacement

Written By: Andrew Optimus Goldheart
  • Comments: 7
Fairphone 1 Midframe Assembly Replacement

Difficulty

Moderate

Steps

6

Time Required

No estimate

Introduction

Use this guide to remove the plastic midframe from your Fairphone to access internal components.

  1. MXI4cSWRnfkli2ij

    • Remove the five 3.9 mm Phillips #000 screws securing the midframe to the display assembly.

    The three upper -next to the SIM blocks- screws are a bit longer that the three others. It is important to keep them like this because if not, they will not tight to the whole.

    Jaime Bosque Torrecilla -

    There are only 5 screws. I see none longer than others.

    Viktor Steiner -

    You're right, I've just done it and it's true. Thanks!

    Aiala -

  2. SfKvwtCMthj3SZau
    SfKvwtCMthj3SZau
    PYBEnY1BVnhjVTjH
    uq3jAbPRdjTMYKEB

    • The midframe is secured to the display assembly by several small plastic clips.

    • Use an opening pick to carefully pry the midframe away from the display assembly.

    • Start just below the volume rocker and work your way down toward the bottom of the phone, freeing the plastic clips along the side.

    No need to be TOO careful. Just remove the whole thing, no stress.

    clem -

    Some stupid person put a sticker on the fifth screw. If you can not find the fifth screw, check if there are any BLACK (yes, black) stickers on top of them. Also, which 'designer' made the first design choice for plastic clips? I WILL FIND YOU. AND KILL YOU. *!&*^#% stupidest way to affirm or secure something!

    maggelo -

    It must be done very carefully: I'd broken both white pieces. Hope has no consequences ...

    Aiala -

    You also can start from the interior (white pieces all around batterie place)

    remy.carl.fr -

  3. ZC5FAkIRnhHSs5aj
    ZC5FAkIRnhHSs5aj
    IumJCLtXZOPQoFWX

    • Carefully round the corner, separating the midframe from the display assembly.

  4. kSWQd6TRSPCIYSKb

    • After rounding the next corner, the midframe should be free along the bottom and the sides.

  5. iQkNQ3HpLP6bLiOM
    iQkNQ3HpLP6bLiOM
    RaHnhIAUHnDmxDYa
    KoXhpQOMed4TogZA

    • Run the opening pick and pry along the top seam.

    • To avoid bending or damaging the opening picks, do not pry near to the power switch, USB port, or headphone jack.

  6. ZC1c2AGOq2ZLF2Nx

    • Separate any remaining clips and remove the midframe from the phone.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Andrew Optimus Goldheart

Member since: 17/10/09

502341 Reputation

0 comments