EVGA x17 Programmable Buttons Replacement

Written By: McAuleyC
  • Comments: 0
EVGA x17 Programmable Buttons Replacement

Difficulty

Moderate

Steps

7

Time Required

25 - 40 minutes

Introduction

This guide is meant to help with the replacement of the programmable buttons found on the top of the mouse just below the scroll wheel, the large "sniper" button on the side, and the three smaller buttons side of the mouse just below the "sniper" button.

Before you begin to disassemble the mouse, check the troubleshooting guide related to the programmable buttons. One common issue users experience with the EVGA x17 Gaming Mouse involves updating their drivers and downloading EVGA's RGB Mouse software.

  1. FRZiWw6WKFJv2pbW

    • Remove the mouse skates to reveal 5 screws.

  2. ZZbjDw4FBLAYgqv1

    • Use a Phillips head screwdriver to remove the 5 screws that secure the bottom panel.

  3. 4hqVCkOoyTtkoBDX

    • Remove the weight chamber cover.

  4. CgMTGj5jWtNPLfUv

    • Slowly slide a spudger into and around the bottom of the panel, prying until a "popping" sound is heard.

  5. yuWmg6XthnMkbWvN
    yuWmg6XthnMkbWvN
    o4CpqB35BZKLsLIO

    • Remove the 13 screws on the interior.

    • There are 2 Phillips truss-head tapping screws, large circular heads, and the 11 Phillips screws from the interior.

  6. aVEI1UeLSajOJqUH

    • Carefully slide the middle section out.

  7. KfJZSNV6YWYeYMgk
    KfJZSNV6YWYeYMgk
    qfG2swBqyYKl1IAY

    • Remove screws from each button.

    • Press inwards and pop each button out of their socket.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

McAuleyC

Member since: 18/09/23

145 Reputation

0 comments