Introduction

Use this guide to remove or replace the fan in your Dell Latitude 7410 laptop.

If your laptop overheats, or makes rattling noises when the fan is running, you might need to replace or clean it.

To replace the heatsink, follow this guide.

  1. KVhJSEJn35pRtpTg
    • Allow your laptop's battery to drain below 25% before starting this repair—a charged battery may catch fire if damaged.

    • Unplug all cables, fully shut down your laptop, and close the lid.

  2. ZGA51OPDJSxC2TYs
    • Use a Phillips screwdriver to loosen the eight captive screws securing the back cover.

  3. FLbNUScF6GTmQtVF
    FLbNUScF6GTmQtVF
    4AGQckNfxEpKoEKU
    • Insert an opening pick between the right edge of the back cover and the frame, just below the middle right screw.

  4. DTlPw2pqGIDkkYOf
    DTlPw2pqGIDkkYOf
    CUuCmdhYkBXTfkN2
    • Slide your pick along the right edge to release the clips securing the back cover.

  5. 1OHWpDCm1cXCoZYp
    1OHWpDCm1cXCoZYp
    slJJSckwBnuAAYor
    PYsuRNtnNHwJ6wCv
    • Insert your pick between the left edge of the back cover and the frame, next to the speaker cutout.

    • Slide your pick along the left edge to release the clips.

  6. x65QutnMkQPYHDWq
    x65QutnMkQPYHDWq
    XtCFfNqCafBooWsj
    UePh1xVQ2ittXubl
    • Insert your pick between the back cover and the right display-hinge to release the first clip along the back edge.

    • Slide your pick toward the left hinge until the second clip releases.

  7. qcvfJR5d3mXGNSqY
    qcvfJR5d3mXGNSqY
    EV6QgyotJEQ2Irhk
    • Insert your pick between the front edge of the back cover and the frame, just to the right of the bottom left screw.

    • Slide your pick toward the right edge until the front edge releases from the frame.

  8. oXxrAtcp2JqMPOsF
    oXxrAtcp2JqMPOsF
    GpA6xUysqbjJU5Fr
    • Remove the back cover.

  9. TyeDs4aNSeeQOfTG
    TyeDs4aNSeeQOfTG
    6VSAPrDuD1m6mYjw
    • Grab the black pull tab on the head of the battery connector and pull straight up to disconnect it.

  10. npQQCb4YSDDJoTUG
    npQQCb4YSDDJoTUG
    ZXbkxpQgGKLJuqWj
    PRKpnjlf63i2xYKr
    • Use a spudger to press on alternating sides of the fan connector to "walk" it out of its socket.

  11. wuPktxZBJlTUGtug
    wuPktxZBJlTUGtug
    GmtyU1S2UyQe2d3O
    EN2XgUM3DV2hSMWm
    • Use your Phillips screwdriver to remove the 3 mm screw securing the WLAN connector cover.

    • Remove the cover.

  12. CwBxME1UPrH5pFYU
    • Use your Phillips screwdriver to remove the two 3 mm screws securing the fan.

  13. TJEntpQcS1O51lju
    TJEntpQcS1O51lju
    GjSZGQWwf1yrnDlT
    As51hEXaqXFRkET1
    • Slide the fan out from the heatsink and remove it.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.

Clay Eickemeyer

Member since: 19/09/22

65190 Reputation

0 comments