Analogue Pocket Battery Replacement

Written By: Spencer Day

Comments: 0

Difficulty

Moderate

Steps

Time Required

4 - 5 minutes

Introduction

Use this guide to replace a dead or worn out battery in your Analogue Pocket.

Note: This guide shows how to replace the battery cell and its housing as one assembly. If you're replacing the battery cell itself, follow this guide to extract it from its housing.

Tools

Step 1

Unplug all cables and fully power off your device.
Working on your device requires laying it screen-side down. To prevent damage, lay it on a soft surface such as a towel.

Step 2

Use a T6 Torx screwdriver to remove the four 13.4 mm‑long screws securing the battery shell.

Step 3

Lift the bottom edge of the battery shell to unhook its tabs.
Remove the battery shell.
During reassembly, hook the tabs on the top edge of the battery shell into their slots in the rear shell before securing it in place.

Step 4

Use blunt nose tweezers to pull the battery connector out of its socket on the bottom right corner of your device.
If you're having trouble, try rocking the connector side-to-side to help loosen it.
During reassembly, use the flat end of a spudger to push down on the edges of the connector until it's secure in the socket.