Alcatel Pop 4 Plus Motherboard Replacement

Written By: Pieter Molenaar
  • Comments: 2
Alcatel Pop 4 Plus Motherboard Replacement

Difficulty

Moderate

Steps

9

Time Required

10 minutes

Introduction

The Motherboard is the most complicated part of the phone to remove because almost all of the phones components are connected to it. This guide will show you how to properly remove the Alcatel Pop 4 Plus Motherboard in a few simple steps. Be gentle with removing the connectors and make sure you line them up properly when snapping them back together.

  1. OqlwKJsW3GYXs6RR
    OqlwKJsW3GYXs6RR
    HGwutq6wYZ3wdxKi

    • Remove the back cover by sliding your fingernail in the grove around the edge of the phone and prying it off.

  2. O6BxyaJxrZPBBRGJ
    O6BxyaJxrZPBBRGJ
    ykErhSAVb1TVIld5

    • Remove seventeen 3mm Phillips #000 screws from the mid-frame.

  3. FoX2QmDIjN6KShQW

    • Use the flat end of the spudger, or your fingernail, to pry off the mid-frame.

  4. 31NNOLC5spkJeDQA
    31NNOLC5spkJeDQA
    rmbYLDPWpaWGmDHT

    • Use the flat end of the spudger disconnect the battery from the motherboard.

    • Use the flat end of the spudger tool to pry out the battery.

  5. ZUDxqpYwhrqebXHd
    ZUDxqpYwhrqebXHd
    yIX1sOAWmYsgO4OK

    • Use a spudger to flip up the retaining flap on the USB ribbon cable ZIF socket.

    • Slide the ribbon cable out of the socket.

  6. SwQPGtTrvMQ4maTX
    SwQPGtTrvMQ4maTX
    TRAiPPbNfXkuAJXN

    • Use the flat end of a spudger to disconnect the ribbon cable.

  7. QQCn4NmjptknaGif
    QQCn4NmjptknaGif
    eJrBnO4fvMFEWDNv

    • Using the flat end of the spudger to disconnect the ribbon cable.

  8. GZORf2wEMg6PLUW1
    GZORf2wEMg6PLUW1
    xRRGiv2NnbCT2slh

    • Using the flat end of the spudger, disconnect the camera from the motherboard.

  9. rSwYaDO52UwDkUUD

    • Use the flat end of the spudger to pry off the motherboard.

    Hi, can you show usb dock?Where can I buy the usb dock?. Thank you

    Carlos Reboredo -

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Pieter Molenaar

Member since: 25/01/18

253 Reputation

One comment

Hi

I got my Alcatel Pop 4+ checked and it's Power IC was faulty. How can I replace it

I'm looking for the specific IC used in it if I can get any help regarding it.

NINJA WARRIORS -