Tortuosity
Tortuosity is a property of a curve being tortuous (twisted; having many turns). There have been several attempts to quantify this property. Tortuosity is commonly used to describe diffusion and fluid flow in porous media,[1][2] such as soils and snow.[3]
![](../I/m/Nowitna_river.jpg)
Tortuosity in 2-D
Subjective estimation (sometimes aided by optometric grading scales)[4] is often used.
The simplest mathematical method to estimate tortuosity is the arc-chord ratio: the ratio of the length of the curve (C) to the distance between its ends (L):
Arc-chord ratio equals 1 for a straight line and is infinite for a circle.
Another method, proposed in 1999,[5] is to estimate the tortuosity as the integral of the square (or module) of the curvature. Dividing the result by length of curve or chord has also been tried.
In 2002 several Italian scientists[6] proposed one more method. At first, the curve is divided into several (N) parts with constant sign of curvature (using hysteresis to decrease sensitivity to noise). Then the arc-chord ratio for each part is found and the tortuosity is estimated by:
In this case tortuosity of both straight line and circle is estimated to be 0.
In 1993[7] Swiss mathematician Martin Mächler proposed an analogy: it’s relatively easy to drive a bicycle or a car in a trajectory with a constant curvature (an arc of a circle), but it’s much harder to drive where curvature changes. This would imply that roughness (or tortuosity) could be measured by relative change of curvature. In this case the proposed "local" measure was derivative of logarithm of curvature:
However, in this case tortuosity of a straight line is left undefined.
In 2005 it was proposed to measure tortuosity by an integral of square of derivative of curvature, divided by the length of a curve:[8]
In this case tortuosity of both straight line and circle is estimated to be 0.
Fractal dimension has been used to quantify tortuosity.[9] The fractal dimension in 2D for a straight line is 1 (the minimal value), and ranges up to 2 for a plane-filling curve or Brownian motion.[10]
In most of these methods digital filters and approximation by splines can be used to decrease sensitivity to noise.
Tortuosity in 3-D
![](../I/m/lossy-page1-220px-Tortuosity_via_geodesic_distance_calculation.tif.jpg)
Usually subjective estimation is used. However, several ways to adapt methods estimating tortuosity in 2-D have also been tried. The methods include arc-chord ratio, arc-chord ratio divided by number of inflection points and integral of square of curvature, divided by length of the curve (curvature is estimated assuming that small segments of curve are planar).[13] Another method used for quantifying tortuosity in 3D has been applied in 3D reconstructions of solid oxide fuel cell cathodes where the Euclidean distance sums of the centroids of a pore were divided by the length of the pore.[14]
Applications of tortuosity
Tortuosity of blood vessels (for example, retinal and cerebral blood vessels) is known to be used as a medical sign.
In mathematics, cubic splines minimize the functional, equivalent to integral of square of curvature (approximating the curvature as the second derivative).
In many engineering domains dealing with mass transfer in porous materials, such as hydrogeology or heterogeneous catalysis, the tortuosity refers to the ratio of the diffusivity in the free space to the diffusivity in the porous medium[15] (analogous to arc-chord ratio of path). Strictly speaking, however, the effective diffusivity is proportional to the reciprocal of the square of the geometrical tortuosity[16]
Because of the porous materials found in several layers of fuel cells, the tortuosity is an important variable to be analyzed.[17] It is important to notice that there are different kind of tortuosity, i.e., gas-phase, ionic and electronic tortuosity.
In acoustics and following initial works by Maurice Anthony Biot in 1956, the tortuosity is used to describe sound propagation in fluid-saturated porous media. In such media, when frequency of the sound wave is high enough, the effect of viscous drag force between the solid and the fluid can be ignored. In this case, velocity of sound propagation in the fluid in the pores is non-dispersive and compared with the value of the velocity of sound in the free fluid is reduced by a ratio equal to the square root of the tortuosity. This has been used for a number of applications including the study of materials for acoustic isolation, and for oil prospection using acoustics means.
In analytical chemistry applied to polymers and sometimes small molecules tortuosity is applied in Gel permeation chromatography (GPC) also known as Size Exclusion Chromatography (SEC). As with any chromatography it is used to separate mixtures. In the case of GPC the separation is based on molecular size and it works by the use of stationary media with appropriately dimensioned pores. The separation occurs because larger molecules take a shorter, less tortuous path and elute more quickly and smaller molecules can pass into the pores and take a longer, more tortuous path and elute later.
In pharmaceutical sciences, tortuosity is used in relation to diffusion-controlled release from solid dosage forms. Insoluble matrix formers, such as ethyl cellulose, certain vinyl polymers, starch acetate and others control the permeation of the drug from the preparation and into the surrounding liquid. The rate of mass transfer per area unit is, among other factors, related to the shape of polymeric chains within the dosage form. Higher tortuosity or curviness retards mass transfer as it acts obstructively on the drug particles within the formulation.
HVAC makes extensive use of tortuosity in evaporator and condenser coils for heat exchangers, whereas Ultra-high vacuum makes use of the inverse of tortuosity, which is conductivity, with short, straight, voluminous paths.
Tortuosity has been used in ecology to describe the movement paths of animals.[10]
References
- Epstein, N (1989). "On tortuosity and the tortuosity factor in flow and diffusion through porous media, Chem. Eng". Chemical Engineering Science. 44 (3): 777–779. doi:10.1016/0009-2509(89)85053-5.
- Clennell, Michael (1997). "Tortuosity: A guide through the maze". Geological Society of London, Special Publications. 122 (1): 299–344. Bibcode:1997GSLSP.122..299C. doi:10.1144/GSL.SP.1997.122.01.18.
- Kaempfer, T. U.; Schneebeli, M.; Sokratov, S. A. (2005). "A microstructural approach to model heat transfer in snow". Geophysical Research Letters. 32 (21): L21503. Bibcode:2005GeoRL..3221503K. doi:10.1029/2005GL023873.
- Richard M. Pearson. Optometric Grading Scales for use in everyday practice. Optometry Today, Vol. 43, No. 20, 2003 Archived 2012-04-04 at the Wayback Machine ISSN 0268-5485
- Hart, William E.; Goldbaum, Michael; Cote, Brad; Kube, Paul; Nelson, Mark R. (1999). "Automated measurement of retinal vascular tortuosity". International Journal of Medical Informatics. 53 (2–3): 239–252. doi:10.1016/s1386-5056(98)00163-4. PMID 10193892. Archived from the original on 2009-01-09.
- Enrico Grisan, Marco Foracchia, Alfredo Ruggeri. A novel method for automatic evaluation of retinal vessel tortuosity. Proceedings of the 25th Annual International Conference of the IEEE EMBS, Cancun, Mexico, 2003
- M. Mächler, Very smooth nonparametric curve estimation by penalizing change of curvature, Technical Report 71, ETH Zurich, May 1993
- Patasius, M.; Marozas, V.; Lukosevicius, A.; Jegelevicius, D.. Evaluation of tortuosity of eye blood vessels using the integral of square of derivative of curvature // EMBEC'05: proceedings of the 3rd IFMBE European Medical and Biological Engineering Conference, November 20–25, 2005, Prague. - ISSN 1727-1983. - Prague. - 2005, Vol. 11, p. [1-4]
- Caldwell, I. R.; Nams, V. O. (2006). "A compass without a map: tortuosity and orientation of eastern painted turtles (Chrysemys picta picta) released in unfamiliar territory" (PDF). Canadian Journal of Zoology. 84 (8): 1129–1137. doi:10.1139/z06-102.
- Benhamou, S (2004). "How to reliably estimate the tortuosity of an animal's path: straightness, sinuosity, or fractal dimension?". Journal of Theoretical Biology. 229 (2): 209–220. doi:10.1016/j.jtbi.2004.03.016. PMID 15207476.
- Gommes, C.J., Bons, A.-J., Blacher, S. Dunsmuir, J. and Tsou, A. (2009) Practical methods for measuring the tortuosity of porous materials from binary or gray-tone tomographic reconstructions. American Institute of Chemical Engineering Journal, 55, 2000-2012
- Espinoza-Andaluz, Mayken; Andersson, Martin; Sundén, Bengt (2017). "Computational time and domain size analysis of porous media flows using the lattice Boltzmann method". Computers & Mathematics with Applications. 74: 26–34. doi:10.1016/j.camwa.2016.12.001.
- E. Bullitt, G. Gerig, S. M. Pizer, Weili Lin, S. R. Aylward. Measuring tortuosity of the intracerebral vasculature from MRA images. IEEE Transactions on Medical Imaging, Volume 22, Issue 9, Sept. 2003, p. 1163 - 1171
- Gostovic, D., et al., Three-dimensional reconstruction of porous LSCF cathodes. Electrochemical and Solid State Letters, 2007. 10(12): p. B214-B217.
- Watanabe, Y.; Nakashima, Y. (2001). "Two-dimensional random walk program for the calculation of the tortuosity of porous media". Journal of Groundwater Hydrology. 43: 13–22. Bibcode:2001JGHyd..43...13W. doi:10.5917/jagh1987.43.13. Archived from the original on 2008-07-03.
- Gommes, C.J., Bons, A.-J., Blacher, S. Dunsmuir, J. and Tsou, A. (2009) Practical methods for measuring the tortuosity of porous materials from binary or gray-tone tomographic reconstructions. American Institute of Chemical Engineering Journal, 55, 2000-2012
- Espinoza Andaluz, M., Sundén, B., Andersson, M., & Yuan, J. (2014). Analysis of Porosity and Tortuosity in a 2D Selected Region of Solid Oxide Fuel Cell Cathode Using the Lattice Boltzmann Method. In Fuel Cell Seminar & Energy Exposition