Thrust

Thrust is a reaction force described quantitatively by Newton's third law. When a system expels or accelerates mass in one direction, the accelerated mass will cause a force of equal magnitude but opposite direction on that system.[1] The force applied on a surface in a direction perpendicular or normal to the surface is also called thrust. Force, and thus thrust, is measured using the International System of Units (SI) in newtons (symbol: N), and represents the amount needed to accelerate 1 kilogram of mass at the rate of 1 meter per second per second. In mechanical engineering, force orthogonal to the main load (such as in parallel helical gears) is referred to as thrust.

For other uses, see Thrust (disambiguation).

A Pratt & Whitney F100 jet engine being tested. This engine produces a jet of gas to generate thrust. Its purpose is to propel a jet airplane.

Examples

Forces on an aerofoil cross section

A fixed-wing aircraft generates forward thrust when air is pushed in the direction opposite to flight. This can be done in several ways including by the spinning blades of a propeller, or a rotating fan pushing air out from the back of a jet engine, or by ejecting hot gases from a rocket engine.[2] The forward thrust is proportional to the mass of the airstream multiplied by the difference in velocity of the airstream. Reverse thrust can be generated to aid braking after landing by reversing the pitch of variable-pitch propeller blades, or using a thrust reverser on a jet engine. Rotary wing aircraft and thrust vectoring V/STOL aircraft use engine thrust to support the weight of the aircraft, and vector sum of this thrust fore and aft to control forward speed.

A motorboat generates thrust (or reverse thrust) when the propellers are turned to accelerate water backwards (or forwards). The resulting thrust pushes the boat in the opposite direction to the sum of the momentum change in the water flowing through the propeller.

A rocket is propelled forward by a thrust force equal in magnitude, but opposite in direction, to the time-rate of momentum change of the exhaust gas accelerated from the combustion chamber through the rocket engine nozzle. This is the exhaust velocity with respect to the rocket, times the time-rate at which the mass is expelled, or in mathematical terms:

${\displaystyle \mathbf {T} =\mathbf {v} {\frac {\mathrm {d} m}{\mathrm {d} t}}}$

Where T is the thrust generated (force), ${\displaystyle {\frac {\mathrm {d} m}{\mathrm {d} t}}}$ is the rate of change of mass with respect to time (mass flow rate of exhaust), and v is the speed of the exhaust gases measured relative to the rocket.

For vertical launch of a rocket the initial thrust at liftoff must be more than the weight.

Each of the three Space Shuttle Main Engines could produce a thrust of 1.8 meganewton, and each of the Space Shuttle's two Solid Rocket Boosters 14.7 MN (3,300,000 lbf), together 29.4 MN.[3]

By contrast, the simplified Aid For EVA Rescue (SAFER) has 24 thrusters of 3.56 N (0.80 lbf) each.

In the air-breathing category, the AMT-USA AT-180 jet engine developed for radio-controlled aircraft produce 90 N (20 lbf) of thrust.[4] The GE90-115B engine fitted on the Boeing 777-300ER, recognized by the Guinness Book of World Records as the "World's Most Powerful Commercial Jet Engine," has a thrust of 569 kN (127,900 lbf).

Concepts

Thrust to power

The power needed to generate thrust and the force of the thrust can be related in a non-linear way. In general, ${\displaystyle \mathbf {P} ^{2}\propto \mathbf {T} ^{3}}$. The proportionality constant varies, and can be solved for a uniform flow:

${\displaystyle {\frac {\mathrm {d} m}{\mathrm {d} t}}=\rho A{v}}$

${\displaystyle \mathbf {T} ={\frac {\mathrm {d} m}{\mathrm {d} t}}{v},\mathbf {P} ={\frac {1}{2}}{\frac {\mathrm {d} m}{\mathrm {d} t}}{v}^{2}}$

${\displaystyle \mathbf {T} =\rho A{v}^{2},\mathbf {P} ={\frac {1}{2}}\rho A{v}^{3}}$

${\displaystyle \mathbf {P} ^{2}={\frac {\mathbf {T} ^{3}}{4\rho A}}}$

Note that these calculations are only valid for when the incoming air is accelerated from a standstill – for example when hovering.

The inverse of the proportionality constant, the "efficiency" of an otherwise-perfect thruster, is proportional to the area of the cross section of the propelled volume of fluid (${\displaystyle A}$) and the density of the fluid (${\displaystyle \rho }$). This helps to explain why moving through water is easier and why aircraft have much larger propellers than watercraft.

Thrust to propulsive power

A very common question is how to compare the thrust rating of a jet engine with the power rating of a piston engine. Such comparison is difficult, as these quantities are not equivalent. A piston engine does not move the aircraft by itself (the propeller does that), so piston engines are usually rated by how much power they deliver to the propeller. Except for changes in temperature and air pressure, this quantity depends basically on the throttle setting.

A jet engine has no propeller, so the propulsive power of a jet engine is determined from its thrust as follows. Power is the force (F) it takes to move something over some distance (d) divided by the time (t) it takes to move that distance:[5]

${\displaystyle \mathbf {P} =\mathbf {F} {\frac {d}{t}}}$

In case of a rocket or a jet aircraft, the force is exactly the thrust (T) produced by the engine. If the rocket or aircraft is moving at about a constant speed, then distance divided by time is just speed, so power is thrust times speed:[6]

${\displaystyle \mathbf {P} =\mathbf {T} {v}}$

This formula looks very surprising, but it is correct: the propulsive power (or power available [7]) of a jet engine increases with its speed. If the speed is zero, then the propulsive power is zero. If a jet aircraft is at full throttle but attached to a static test stand, then the jet engine produces no propulsive power, however thrust is still produced. The combination piston engine–propeller also has a propulsive power with exactly the same formula, and it will also be zero at zero speed – but that is for the engine–propeller set. The engine alone will continue to produce its rated power at a constant rate, whether the aircraft is moving or not.

Now, imagine the strong chain is broken, and the jet and the piston aircraft start to move. At low speeds:

The piston engine will have constant 100% power, and the propeller's thrust will vary with speed
The jet engine will have constant 100% thrust, and the engine's power will vary with speed

Excess thrust

If a powered aircraft is generating thrust T and experiencing drag D, the difference between the two, T − D, is termed the excess thrust. The instantaneous performance of the aircraft is mostly dependent on the excess thrust.

Excess thrust is a vector and is determined as the vector difference between the thrust vector and the drag vector.

Thrust axis

The thrust axis for an airplane is the line of action of the total thrust at any instant. It depends on the location, number, and characteristics of the jet engines or propellers. It usually differs from the drag axis. If so, the distance between the thrust axis and the drag axis will cause a moment that must be resisted by a change in the aerodynamic force on the horizontal stabiliser.[8] Notably, the Boeing 737 MAX, with larger, lower-slung engines than previous 737 models, had a greater distance between the thrust axis and the drag axis, causing the nose to rise up in some flight regimes, necessitating a pitch-control system, MCAS.[9][10]

See also

• Aerodynamic force
• Astern propulsion
• Gas turbine engine thrust
• Gimballed thrust, most common in modern rockets
• Pound of thrust (same as pound (force)
• Stream thrust averaging
• Thrust-to-weight ratio
• Thrust vectoring
• Thrust reversal
• Tractive effort

References

1. "What is Thrust?". www.grc.nasa.gov. Archived from the original on 14 February 2020. Retrieved 2 April 2020.
2. "Newton's Third Law of Motion". www.grc.nasa.gov. Archived from the original on 3 February 2020. Retrieved 2 April 2020.
3. "Space Launchers - Space Shuttle". www.braeunig.us. Archived from the original on 6 April 2018. Retrieved 16 February 2018.
4. "AMT-USA jet engine product information". Archived from the original on 10 November 2006. Retrieved 13 December 2006.
5. Yoon, Joe. "Convert Thrust to Horsepower". Archived from the original on 13 June 2010. Retrieved 1 May 2009.
6. Yechout, Thomas; Morris, Steven. Introduction to Aircraft Flight Mechanics. ISBN 1-56347-577-4.
7. Anderson, David; Eberhardt, Scott (2001). Understanding Flight. McGraw-Hill. ISBN 0-07-138666-1.
8. Kermode, A.C. (1972) Mechanics of Flight, Chapter 5, 8th edition. Pitman Publishing. ISBN 0273316230
9. "Control system under scrutiny after Ethiopian Airlines crash". Al Jazeera. Archived from the original on 28 April 2019. Retrieved 7 April 2019.
10. "What is the Boeing 737 Max Maneuvering Characteristics Augmentation System?". The Air Current. 14 November 2018. Archived from the original on 7 April 2019. Retrieved 7 April 2019.