Survival suit

A survival suit, or as it is more accurately and currently referred to as, an immersion suit, is a special type of waterproof dry suit that can protect the wearer from hypothermia if immersed in cold water, after abandoning a sinking or capsized vessel, especially in the open ocean. Immersion suits usually have built-in feet (boots), and a hood, and either built-in gloves or watertight wrist seals. Suits manufactured by several manufacturers also include an inflatable pillow which is permanently attached high on the back, or an inflatable tube that is attached with zippers at two points on the chest, each side of the main zipper, and circles the back. When inflated, both of these devices provide enhanced stability to the wearer, so that, if conscious, allows them to have enhanced stability with the head above water, and the ability to keep wind and seas from striking the face. The inflation tube is routed from the inflatable pillow over the left shoulder of the user, and secured in a loop on the chest. Some immersion suits are manufactured with straps/clips and hooks to allow multiple survivors to attach to one another in the water. This practice keeps survivors together. As well, some suits are manufactured with built-in hoisting lanyards, to allow easier retrieval from vessels with a higher seaboard, that may have manual or mechanical hoisting capabilities.

Practicing with a survival suit

The first record of what has previously been known as a "survival suit" was in 1930 when a New York firm American Life Suit Corporation offered merchant and fishing firms what it called a safety suit for crews of ocean vessels. The suit came packed in a small box and was put on like a boilersuit.[1]

The ancestor of these suits was already invented in 1872 by Clark S Merriman to rescue steamship passengers. It was made from rubber sheeting and became famous by the swim records of Paul Boyton. It was essentially a pair of rubber pants and shirt cinched tight at the waist with a steel band and strap. Within the suit were five air pockets the wearer could inflate by mouth through hoses. Similar to modern-day drysuits, the suit also kept its wearer dry. This essentially allowed him to float on his back, using a double-sided paddle to propel himself, feet-forward. Additionally, he could attach a small sail to save stamina while slowly drifting to shore (because neither emergency radio transmitters nor rescue helicopters were invented yet).[2][3]

The first immersion suit to gain USCG approval was invented by Gunnar Guddal. Eventually the suit became accepted as essential safety gear.[4][5]

Usage

These suits are in two types:

Designed to be worn all the time

This type is chosen to fit each wearer. They are often worn by deep-sea fishermen who work in cold water fishing grounds.

Some of these garments overlap into scubadiver-type drysuits. Others may have many of the features of an immersion suit.

Since humans are warm blooded and sweat to cool themselves, suits that are worn all the time usually have some method for sweat to evaporate and the wearer to remain dry while working.

  • Some aircraft aircrew dry suits are constructed of a breathable, fire-retardant material that allows water vapor to escape but prevents liquid from entering.
  • Some aircraft pilot survival suits use a solid impregnable material such as rubber-backed cotton, which is connected to a forced-air cooling system. Ventilation air is supplied via air hoses inside the vehicle cabin. In an emergency, the hoses can be rapidly disconnected and the ventilation access ports close on the suit.

Only worn in emergency / vessel abandonment

The first 'survival suits' in Europe were invented by Daniel Rigolet, captain of a French oil tanker. Others had experimented on similar suits abroad.

Unlike work suits, "quick don" immersion suits are not normally worn for work, but are stowed in an accessible location onboard the craft. The operator may be required to have one immersion suit of the appropriate size onboard for each crew member, and other passengers. If an immersion suit is not accessible both from a crew member's work station and berth, then two accessible suits must be provided.

This type of immersion suit's flotation and thermal protection is usually better than an immersion protection work suit, and if the suit is properly maintained, may extend in-water survival for a person who is trained in its use.

An adult immersion suit is often a large bulky one-size-fits-all design meant to fit a wide range of sizes. Two types of materials are used. Neoprene suits, without additional insulation, and suits constructed of a trilaminate waterproof material, with a snap-in insulating liner made from thin foam sheets cut and glued to form the suit, with a rayon backing to make donning the suit easier. These suits typically have large oversize booties to accommodate various foot sizes. Gloves may be built into the suit, or be stored in easy access pouches art the end of the sleeves. These suits will have a waterproof zipper in front for access. These zippers must be properly maintained or the suit may not function properly. There is generally a face flap to somewhat seal water out around the neck and protect the wearer from ocean spray. Because of the oversized booties and large mittens, quick don immersion suits are often known as "Gumby suits," after the 1960s-era children's toy.

The integral gloves may be a thin waterproof non-insulated type to give the user greater dexterity during donning and evacuation, with a second insulating outer glove tethered to the sleeves to be worn while immersed.

A ship's captain (or master) may be required to hold drills periodically to ensure that everyone can quickly access the immersion suit storage in an emergency, and don the suit in the allotted amount of time. In the event of an emergency, it should be possible to put on an immersion suit in 60 seconds.

The Submarine Escape Immersion Equipment is a type of survival suit that can be used by sailors when escaping from a sunken submarine. The suit is donned before escaping from the submarine and then inflated to act as a liferaft when the sailor reaches the surface.

Construction

Survival suits are normally made out of red or bright fluorescent orange or yellow fire-retardant neoprene, for high visibility on the open sea. The neoprene material used is a synthetic rubber closed-cell foam, containing a multitude of tiny air bubbles making the suit sufficiently buoyant to also be a personal flotation device.

The seams of the neoprene suit are sewn and taped to seal out the cold ocean water, and the suit also has strips of SOLAS specified retroreflective tape on the arms, legs, and head to permit the wearer to be located at night from a rescue aircraft or ship.

Open neck vs closed neck sealing

The method of water sealing around the face can affect wearer comfort. Low-cost quick-donning suits typically have an open neck from chest to chin, closed by a waterproof zipper. However, the zipper is stiff and tightly compresses around the face resulting in an uncomfortable fit intended for short-duration use until the wearer can be rescued. The suit material is typically very rigid and the wearer is unable to look to the sides easily.

Suits intended for long-term worksuit use, or donned by rescue personnel, typically have a form-fitting neck-encircling seal, with a hood that conforms to the shape of the chin. This design is both more comfortable and allows the wearer to easily turn their head and look up or down. The suit material is designed to be either loose or elastic enough to allow the wearer to pull the top of the suit up over their head and then down around their neck.

Safety features

Immersion suits can also be equipped with extra safety options such as:

  • A whistle to permit the wearer to signal for help
  • An emergency strobe light beacon.
  • Tethered mittens to better insulate the hands
  • A PLB, AIS Man Overboard Transponder.
  • Sea dye markers and floating streamers to increase visibility in water.

Inflatable survival suits

The inflatable survival suit is a special type of survival suit, recently developed, which is similar in construction to an inflatable boat, but shaped to wrap around the arms and legs of the wearer. This type of suit is much more compact than a neoprene survival suit, and very easy to put on when deflated since it is just welded from plastic sheeting to form an air bladder.

Once the inflatable survival suit has been put on and zipped shut, the wearer activates firing handles on compressed carbon dioxide cartridges, which punctures the cartridges and rapidly inflates the suit. This results in a highly buoyant, rigid shape that also offers very high thermal retention properties.

However, like an inflatable boat, the inflatable survival suit loses all protection properties if it is punctured and the gas leaks out. For this reason, the suit may consist of two or more bladders, so that if one fails, a backup air bladder is available.

Immersion suit maintenance

Each immersion suit needs to be regularly checked and maintained properly in order to be ready for use all the time. The maintenance of the immersion suits kept on board of the vessels must be done according to the rules of the International Maritime Organization (IMO). There are two Guidelines issued by IMO - MSC/Circ.1047 [6] and MSC/Circ.1114 [7] in relation to immersion suits’ maintenance.

The first one gives instruction for monthly inspection and maintenance which must be done by the ship's crew.[8] The second one is concerning pressure testing which can be done only with special equipment. Usually, it is done ashore by specialized companies but can be done also onboard the vessels if practical. It must be performed every three years for immersion suits less than 12 years old and every second year on older ones. The years are counted from the suit's date of manufacture.

Images
  • Instructing a crew on use of a survival suit
  • A survival suit (Statoil)
  • Naval air pilot's immersion suit, with NBC mask with full rubber hood so it can be used as a hazmat suit
  • Immersion suit of Russian submarine's crew
gollark: What?
gollark: ... no, that is probably not true.
gollark: This is more <#645777807275851776>-y.
gollark: What are you on about? Are you talking about... actual clouds?
gollark: What does that MEAN? What does that have to do with anything?

References
  1. "Safety Suit Like Coveralls Warm and Water Tight" Popular Mechanics, March 1930
  2. Mebkimak, Olaek S. (Jul 16, 1872), Improvement in life-preserving dresses, retrieved 2016-01-28
  3. Sullivan, Colleen (2006). Roughing It In Rubber. BookSurge Publishing. pp. 12–23. ISBN 1419640216.
  4. Sullivan, Patricia (May 22, 2006). "Gunnar Guddal, 77; Invented Lifesaving Immersion Suit". Washington Post. Retrieved 2016-01-28.
  5. "USMSA News Flash! ~ Gunnar Guddal ~ - United States Marine Safety Association". United States Marine Safety Association. Retrieved 2016-01-28.
  6. MSC/Circ.1047 (PDF)
  7. MSC/Circ.1114 (PDF)
  8. Immersion suit maintenance
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.