ST Aero FanTail
The FanTail is a Vertical Take-off and Landing (VTOL) Unmanned Air Vehicle developed by ST Aerospace.
A mock-up of the UAV made its first show appearance at Asian Aerospace 2006 in Singapore (21–25 February), along with the smaller original FanTail 3000 VTOL UAV, which has already flown about 100 hours.
Models
- FanTail 3000 (Prototype)
- Overall weight: 3 kg
- Payload weight: 0.9 kg
- Overall length: 76 cm
- Rotor diameter: 29 cm
- Width (excluding landing gear):
- Height(including landing gear):
- Maximum level speed in horizontal position:
- Endurance:
- Operating distance:
- Flight Control:
- Airframe: modular carbon-fibre composite construction
- Powerplant:
- Ground Control: Window notebook-based compact ground control station with datalink terminal
- FanTail 5000
- Overall weight: 5.5 kg
- Payload weight: 0.4 kg
- Overall length:
- Rotor diameter: 46 cm
- Width (excluding landing gear): 59 cm
- Height(including landing gear): 115 cm
- Maximum level speed in horizontal position: 60 Knot / 111 km/h
- Endurance: 30 minutes in hover
- Operating distance: 5 km
- Flight Control: pre-programmed autonomous waypoint navigation using GPS
- Airframe: modular carbon-fibre composite construction
- Powerplant: 3.5 hp two-stroke gasoline engine
- Ground Control: Window notebook-based compact ground control station with datalink terminal
gollark: A web interface in the style of the heavdrone one, for potatOS.
gollark: Also, I should make a heavdrone interface for PotatOS.
gollark: We have dedicated offices for them?
gollark: If I doubled the amount of command computers in use plottography could occur within SECONDS.
gollark: They already run at perfectly okay ish speeds with GTech™ Distributed Plottography™.
References
- ST Aerospace FanTail II
- Damian Kemp Jane's Aviation, AA 2006: FanTail 5000 prototype flight set for March, 20 February 2006
- FanTail VTOL Miniature UAV
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.