Liquid water content

The liquid water content (LWC) is the measure of the mass of the water in a cloud in a specified amount of dry air. It is typically measured per volume of air (g/m³) or mass of air (g/kg) (Bohren, 1998). This variable is important in figuring out which types of clouds are likely to form and is strongly linked to three other cloud microphysical variables: the cloud drop effective radius, the cloud drop number concentration, and the cloud drop size distribution (Wallace, 2006). Being able to determine the cloud formations that are likely to occur is extremely useful for weather forecasting as cumulonimbus clouds are related to thunderstorms and heavy rain whereas cirrus clouds are not directly associated with precipitation.

Characteristics

The liquid water content of a cloud varies significantly depending on the type of clouds present in the atmosphere at a given location. The classification of the cloud is highly related to the liquid water content as well as the origin of the cloud. The combination of these two allows a forecaster to more readily predict the types of conditions that will be in an area based on the types of clouds that are forming or have already formed.

Relation to classification of clouds

Clouds that have low densities, such as cirrus clouds, contain very little water, thus resulting in relatively low liquid water content values of around .03 g/m³. Clouds that have high densities, like cumulonimbus clouds, have much higher liquid water content values that are around 1-3 g/m³, as more liquid is present in the same amount of space. Below is a chart giving typical LWC values of various cloud types (Thompson, 2007).

Cloud Type	LWC (g/m³)
cirrus	.03
fog	.05
stratus	.25-.30
cumulus	.25-.30
stratocumulus	.45
cumulonimbus	1.0-3.0

Maritime vs. continental

Maritime clouds tend to have fewer water droplets than continental clouds. The majority of maritime clouds have droplet concentrations between 100 drops/cm³ and about 200 drops/cm³ (Wallace, 2006). Continental clouds have much higher droplet concentrations ranging up to around 900 drops/cm³. (Wallace, 2006). However, the droplet radius in maritime clouds tend to be larger, so that the end result is that the LWC is relatively similar in both types of air masses for the same types of clouds (Linacre, 1998).

Measuring techniques

There are several ways that can be used to measure the liquid water content of clouds.

One way involves an electrically heated wire. The wire is attached to the power supply and is situated on the outside of the airplane. As it moves through a cloud, water droplets hit the wire and evaporate, reducing the temperature of the wire. The resistance caused by this is measured and is used to determine the power needed to maintain the temperature. The power can be converted to a value for the LWC. (Wallace, 2006).

Another way involves an instrument that uses scattered light from a large number of drops. This value is then converted to a value for the LWC. (Wallace, 2006).

A cloud chamber can also be used to simulate adiabatic ascent in the atmosphere through the decrease of pressure by removing air inside the chamber. A series of equations shown in the section below show how the LWC is obtained in this procedure. (Thompson, 2007).

Equations/relations

Various equations are useful in determining LWC and the effects that influence it. One of the most significant variables related to the LWC is the droplet concentration of a cloud.

Cloud droplet concentration

The droplet concentration of a cloud is the number of water droplets in a volume of cloud, typically a cubic centimeter (Wallace, 2006). The formula for the droplet concentration is as follows.

n=N/V

In this equation, N is the total number of water droplets in the volume, and V is the total volume of the cloud being measured. Converting this to a LWC gives an equation that is shown below.

LWC=(m_{w}*n)/N

In this equation, m_w is the mass of the water in the air parcel.

Cloud chamber

A common type of experiment is one that involves a cloud chamber that is de-pressurized to simulate adiabatic ascent of air parcels. Determining LWC is a simple calculation shown below (Thompson, 2007).

LWC=m_{w}/V_{c}

M_w is the mass of the water in the cloud chamber and V_c is the volume of the cloud chamber. Obtaining the mass of the liquid water in the cloud chamber is possible through an equation involving the latent heat of condensation (Thompson, 2007).

m_{w}={\frac {-m_{a}\cdot c_{p}\cdot \Delta T_{a}}{L_{c}(T)}}

In the equation above, L_c(T) is the latent heat of condensation of water at temperature T, m_a is the mass of the air in the cloud chamber, c_p is the specific heat of dry air at constant pressure and $\Delta T_{a}$ is the change in the temperature of the air due to latent heat.

gollark: Oh, like C++?

gollark: C doesn't have a `string`, does it?

gollark: Probably, although likely not with that exact syntax.

gollark: In any sane language, that would cause several type errors or something.

gollark: Yes, further evidence of PHP bad.

References

Wallace, John M.; Hobbs, Peter V. (2006). Atmospheric Science: An Introductory Survey (2nd ed.). U.K. Elsevier Inc. ISBN 012732951X.
Bohren, Craig F.; Albrecht, Bruce A. (1998). Atmospheric Thermodynamics (1st ed.). Oxford University Press. ISBN 0-19-509904-4.
Linacre, E.; Geerts, B. (August 1999), Cloud liquid water content, drop sizes, and number of droplets., retrieved 2008-03-12
Thompson, Anne (2007). "Simulating the Adiabatic Ascent of Atmospheric Air Parcels using the Cloud Chamber". Department of Meteorology, Penn State. Cite journal requires |journal= (help)

This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.