Harvesting lightning energy

Since the late 1980s, there have been several attempts to investigate the possibility of harvesting lightning energy. A single bolt of lightning carries a relatively large amount of energy (approximately 5 gigajoules[1] or about the energy stored in 38 gallons of gasoline). However, this energy is concentrated in a small location and is passed during an extremely short period of time (microseconds[2]); therefore, extremely high electrical power is involved.[3] 5 gigajoules over 10 microseconds is equal to 500 terawatts. Because lightning bolts vary in voltage and current, a more average calculation would be 10 gigawatts.[4] It has been proposed that the energy contained in lightning be used to generate hydrogen from water, to harness the energy from rapid heating of water due to lightning,[5] or to use a group of lightning arresters to harness a strike, either directly or by converting it to heat or mechanical energy, or to use inductors spaced far enough away so that a safe fraction of the energy might be captured.[6]

Overview

A technology capable of harvesting lightning energy would need to be able to rapidly capture the high power involved in a lightning bolt. Several schemes have been proposed, but the ever-changing energy involved in each lightning bolt renders lightning power harvesting from ground-based rods impractical – too high, it will damage the storage, too low and it may not work. Additionally, lightning is sporadic, and therefore energy would have to be collected and stored; it is difficult to convert high-voltage electrical power to the lower-voltage power that can be stored.[5]

In the summer of 2007, an alternative energy company called Alternate Energy Holdings, Inc. (AEHI) tested a method for capturing the energy in lightning bolts. The design for the system had been purchased from an Illinois inventor named Steve LeRoy, who had reportedly been able to power a 60-watt light bulb for 20 minutes using the energy captured from a small flash of artificial lightning. The method involved a tower, a means of shunting off a large portion of the incoming energy, and a capacitor to store the rest. According to Donald Gillispie, CEO of AEHI, they "couldn't make it work," although "given enough time and money, you could probably scale this thing up... it's not black magic; it's truly math and science, and it could happen."[7]

According to Martin A. Uman, co-director of the Lightning Research Laboratory at the University of Florida and a leading authority on lightning,[8] a single lightning strike, while fast and bright, contains very little energy, and dozens of lightning towers like those used in the system tested by AEHI would be needed to operate five 100-watt light bulbs for the course of a year. When interviewed by The New York Times, he stated that the energy in a thunderstorm is comparable to that of an atomic bomb, but trying to harvest the energy of lightning from the ground is "hopeless".[7]

Another major challenge when attempting to harvest energy from lightning is the impossibility of predicting when and where thunderstorms will occur. Even during a storm, it is very difficult to tell where exactly lightning will strike.[1]

Directed plasma channels

To facilitate the harvesting of lightning, a laser-induced plasma channel (LIPC) could theoretically be used to allow lightning to strike in a predictable location. A high power laser could be used to form an ionized column of gas, which would act as an atmospheric conduit for electrical discharges of lightning, which would direct the lightning to a ground station for harvesting.[9]

Teramobile,[10] an international project initiated jointly by a French-German collaboration of CNRS (France) and DFG (Germany), has managed to trigger electric activity in thunderclouds by ultrashort lasers. A large amount of power is necessary, 5 terawatts, over the short pulse duration. For the moment, the application of laser-channeled lightning is to use energy to divert the lightning and prevent damage instead of harvesting the lightning energy.[11]

gollark: Yes, this is the main barrier to its use.
gollark: They can be observed in high-energy collisions mostly.
gollark: This does, however, require a particle accelerator and detector very near the gay source.
gollark: Detection of mass anomalies in certain gauge bosons. They couple with the gay field, so high-energy disturbances in it can be measured.
gollark: You have a bot, you implement it.

See also

References
  1. "Could you power a city with lightning?". physics.org. Retrieved 1 September 2011.
  2. Yasuhiro Shiraishi; Takahiro Otsuka (September 18, 2006). "Direct measurement of lightning current through a wind turbine generator structure". Electrical Engineering in Japan. 157 (4): 42. doi:10.1002/eej.20250.
  3. "The Electrification of Thunderstorms," Earle R. Williams, Scientific American, November 1988, pp. 88–99
  4. Dvorak, Paul. "How Much Power in a Bolt of Lightning". Windpower. Retrieved 1 October 2016.
  5. Knowledge, Dr. (October 29, 2007). "Why can't we capture lightning and convert it into usable electricity?". The Boston Globe. Retrieved August 29, 2009.
  6. Helman, D.S. (2011). "Catching lightning for alternative energy". Renewable Energy. 36 (5): 1311–1314. doi:10.1016/j.renene.2010.10.027.
  7. Glassie, John (December 9, 2007). "Lightning Farms". The New York Times. Retrieved August 29, 2009.
  8. Uman Receives 2001 Fleming Medal. www.agu.org
  9. Discovery News Lighting Control https://www.youtube.com/watch?v=eBzxn2LEJoE
  10. http://www.teramobile.org/teramobile.html
  11. Jérôme Kasparian; Jean-Pierre Wolf (2010). "On lightning control using lasers" (PDF). Progress in Ultrafast Intense Laser Science. 98: 109–122.
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.