Enhanced coal bed methane recovery

Enhanced coal bed methane recovery is a method of producing additional coalbed methane from a source rock, similar to enhanced oil recovery applied to oil fields. Carbon dioxide (CO2) injected into a bituminous coal bed would occupy pore space and also adsorb onto the carbon in the coal at approximately twice the rate of methane (CH4), allowing for potential enhanced gas recovery.[1] This technique may be used in conjunction with carbon capture and storage in mitigation of global warming where the carbon dioxide that is sequestered is captured from the output of fossil fuel power plants.

A research project at ETH Zurich is studying the process of pumping carbon dioxide into unminable coal seams and recovering the methane that is subsequently displaced.

An extensive experimental investigation about the process of desorbing methane by adsorbing carbon dioxide in real coal samples was performed. The proof of principle and the technical feasibility of the method could be verified with these measurements. These research results indicate that CBM can become an alternative to conventional natural gas. ECBM provides additional to CBM the advantage of long-term CO2 storage in the underground coal seams.[2]

However, without other incentives, enhanced coal bed methane recovery is not economical as the commercial value of the released methane does not completely offset the cost of pumping.[3]

Penetration of CO2 into coal is simulated using a stress-enhanced diffusion model.[4][5]

See also

Further reading
  • Reznik, A., Singh, P. K., and Foley, W. L., 1982, An analysis of the effect of carbon dioxide injection on the recovery of in-situ methane from bituminous coal: An experimental simulation: Society of Petroleum Engineers/U.S. Department of Energy 10822
  • Gale, J., and Freund, P., 2001, Coal-bed methane enhancement with CO2 sequestration worldwide potential: Environmental Geosciences, v. 8, no. 3, p. 210–217.
  • Schroeder, K., Ozdemir, E., and Morsi, B.I., 2002, Sequestration of carbon dioxide in coal seams: Journal of Energy and Environmental Research, v. 2, no. 1. p. 54–63. (from U.S. Department of Energy, National Energy Technology Laboratory, First National Conference on Carbon Sequestration, 2001).

References
  1. Wickstrom, Lawrence H.; Ernie R. Slucher; Mark T. Baranoski; Douglas J. Mullett (2008). "Geologic Assessment of the Burger Power Plant and Surrounding Vicinity for Potential Injection of Carbon Dioxide" (PDF). Columbus, Ohio: Ohio Geological Survey. Open-File Report 2008-1. Archived from the original (PDF) on 2008-12-31. Retrieved 2008-06-21.
  2. "Investigation of Enhanced Coal Bed Methane (ECBM) Processes - Gravimetric Adsorption Measurements under Realistic Conditions". Archived from the original on 2014-04-23. Retrieved 2013-07-24.
  3. "ETH - SPL - Enhanced coal bed methane recovery". ETH Zurich. 2006-08-31. Archived from the original on 2011-07-06.
  4. F. J. Vermolen, M.G. Gharasoo, P. L. J. Zitha, J. Bruining. (2009). Numerical Solutions of Some Diffuse Interface Problems: The Cahn-Hilliard Equation and the Model of Thomas and Windle. IntJMultCompEng,7(6):523–543.
  5. A. Mikelić and J. Bruining. (2008). Analysis of Model Equations for Stress-Enhanced Diffusion in Coal Layers. Part I: Existence of a Weak solution. SIAM J. Math. Anal.,40:1671-1691
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.