Emission test cycle

An emission test cycle is a protocol contained in an emission standard to allow repeatable and comparable measurement of exhaust emissions for different engines or vehicles. Test cycles specify the specific conditions under which the engine or vehicle is operated during the emission test. There are many different test cycles issued by various national and international governments and working groups.[1] Specified parameters in a test cycle include a range of operating temperature, speed, and load. Ideally these are specified so as to accurately and realistically represent the range of conditions under which the vehicle or engine will be operated in actual use. Because it is impractical to test an engine or vehicle under every possible combination of speed, load, and temperature, this may not actually be the case.[2] Vehicle and engine manufacturers may exploit the limited number of test conditions in the cycle by programming their engine management systems to control emissions to regulated levels at the specific test points contained in the cycle, but create a great deal more pollution under conditions experienced in real operation but not represented in the test cycle. This results in real emissions higher than the standards are supposed to allow, undermining the standards and public health.[3][4]

"Smog check" redirects here. For the program in California, see California Smog Check Program.

Application

Emission test cycles are typical tests for research and development activities on engines at automobile OEMs.
The commonly used hardware platforms therefore are:

  • engine test stand - for just a single engine
  • vehicle test stand (also "chassis dynamometer" or "chassis dyno" or "emission dyno") - for the complete car with engine
  • ASM Test - Accelerated Simulation Mode: (California inspections) Vehicles tested at 15 MPH & 25 MPH where vehicle undergoes a load.
gollark: Hmm.
gollark: 200 °F
gollark: 200 Farenheit
gollark: 200 degrees Farenheit
gollark: 20006 farenheit

References
  1. Dieselnet overview of commonly used test cycles
  2. Poor European test standards understate air pollution from cars Archived 2005-10-29 at the Wayback Machine, European Environment Agency, 19 October 2004
  3. Cycle beating and the EU test cycle for Cars Archived 2010-12-14 at the Wayback Machine, European Federation for Transport and Environment, November 1998
  4. "Archived copy" (PDF). Archived from the original (PDF) on 2013-10-30. Retrieved 2013-02-13.CS1 maint: archived copy as title (link)

See also


This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.