Black and burst

Black and burst also known as bi-level sync and black burst is an analogue signal used in broadcasting. It is a composite video signal with a black picture.[1] It is a reference signal to synchronise video equipment, in order to have them output video signals with the same timing. This allows seamless switching between two video signals.

The sub carrier 'burst' seen from waveform monitor

Black and burst can also be used to synchronise colour phase. This provided timing accuracy in the order of tens of nanoseconds which was necessary to perform e.g. analogue video mixing.

Black and burst exists for various colour TV standards, such as PAL, NTSC and SECAM. Because the black and burst signal is a normal video signal, it is transportable via normal video cables and through video distribution equipment.[2]

History

Before colour TV existed, the reference signal was also a black video signal. Inaccuracies meant the video picture would be shifted.

With the introduction of colour, the reference had to be much more accurate. In every composite video signal a reference burst is present in the horizontal sync portion, so all equipment in the chain will be synchronised roughly 16000 times per second. This regular synchronisation is necessary because the colour information is transmitted via quadrature amplitude modulation on the high-frequency colour signal. Incorrect synchronisation means the phase will be off, and consequently the colour will be incorrect. Creating broadcast television usually involves mixing video signals. When doing this in an analogue way, it is essential that all signals have the same colour phase, which was achieved by synchronising all cameras with a black and burst signal. Because of cable length differences, every camera required a (often only slightly) different timing. This could be tuned at the reference source, and/or at the camera.

Black and burst is being replaced by tri-level sync, but as of 2020 it is still quite common. Because the signal chains are now digital, which allows buffering, the timing requirements are not as strict anymore.

Waveform

Its natural waveform is a negative pulse with a level of -40 IRE followed by 10 cycles of the colour sub carrier of video. For most variants of PAL video, the frequency of the sub carrier is 4.43361875 MHz.[3]

gollark: https://images-ext-2.discordapp.net/external/sOO6Mw-5FiQKudlPMgEmXZwwCeetPF5fcEGVf-QnErM/https/media.discordapp.net/attachments/426116061415342080/925432567417696396/Screenshot_20211224-143635_YouTube.jpg
gollark: Do NOT trust printers.
gollark: My status will never change for any reason until it does.
gollark: Bots already look at all messages so they can detect commands in them. Except newer /-based ones, I guess.
gollark: Computers are 3 fast. This isn't an issue.

See also

References
  1. Michael Talbot-Smith (1 January 1994). Audio Engineer's Reference Book. Focal Press. ISBN 978-0-7506-0386-7.
  2. Alan Pemberton, "World TV Standards and Waveforms", retrieved 2016 by archive.org
  3. TV and Video Engineers Handbook, Third Edition - Eugene Trundle. Page 14. 1999 ISBN 0-7506-4194-0 Newnes Press
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.