Aerodrome beacon

An aerodrome beacon or rotating beacon or aeronautical beacon is a beacon installed at an airport or aerodrome to indicate its location to aircraft pilots at night.

Not to be confused with Airway beacon.
This article is about identifying airports to overhead aircraft. For sending information to travellers' phones, see Bluetooth low energy beacon.
A portable rotating beacon on display at the Alberta Aviation Museum

An aerodrome beacon is mounted on top of a towering structure, often a control tower, above other buildings of the airport. It produces flashes similar to that of a lighthouse.

Airport and heliport beacons are designed in such a way to make them most effective from one to ten degrees above the horizon; however, they can be seen well above and below this peak spread. The beacon may be an omnidirectional flashing xenon strobe, or it may be an aerobeacon rotating at a constant speed which produces the visual effect of flashes at regular intervals. Flashes may be of one, two, or three alternating colors (described below).

In the United States

In the United States, the Federal Aviation Administration (FAA) has established the following rules for airport beacons:[1]

Flashing rates

  1. 24 to 30 per minute for beacons marking airports, landmarks, and points on Federal airways
  2. 30 to 45 per minute for beacons marking heliports

Color combinations

  1. White and Green — Lighted land airport
  2. Green alone* — Lighted land airport
  3. White and Yellow — Lighted water airport
  4. Yellow alone* — Lighted water airport
  5. Green, Yellow, and White — Lighted heliport
  6. White, White, Green** — Military Airport
  7. White, Green, Amber — Hospital and/or Emergency Services Heliport
*Green alone or yellow alone is used only in connection with a white-and-green or white-and-yellow beacon display, respectively.
**Military airport beacons flash alternately white and green, but are differentiated from civil beacons by two quick white flashes between the green flashes.

In Class B, C, D, and E surface areas, operation of the airport beacon between sunrise and sunset often indicates that the ground visibility is less than 3 miles and/or the ceiling is less than 1,000 feet. This is true particularly at locations where beacon controls are available to air traffic control personnel;[2] however there is no regulation requiring daytime operation.[1]


At some locations with operating control towers, ATC personnel turn the beacon on or off with controls in the tower. At many airports the airport beacon is turned on by a photoelectric cell or time clocks, and ATC personnel cannot control them. [1]

In Canada

In Canada, the regulations are different. Lighted aerodromes are equipped with white single flash beacons operating at a frequency of 20 to 30 flashes per minute. Heliports with beacons exhibit the morse letter H (4 short flashes) at a rate of 3 to 4 groups per minute.[3]

gollark: I know that. I'm saying that it's wrong.
gollark: "so we'll make everyone immortal, but also have random people with no oversight kill arbitrary people for ??? reasons" - VERY INTELLIGENT PEOPLE.
gollark: That was fictional! It was also really stupid!
gollark: Also, that would effectively just turn over control to whoever writes the objective function/manages the computing stuff involved.
gollark: Doing all governance tasks basically requires AGI. We do not *have* AGI, and if we get it there will be bigger problems.

See also

Notes
  1. AJV-8, Air Traffic Procedures (2019-08-15). "Aeronautical Information Manual". Federal Aviation Administration. 2–1–10. Retrieved 2019-08-31.
  2. AJV-8, Air Traffic Procedures (2019-08-15). "FAA JO 7110.65Y – Air Traffic Control". Federal Aviation Administration. 3–4–18. Retrieved 2019-08-31.
  3. Transport Canada (23 October 2008). "TC AGA". Archived from the original on 17 June 2008.
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.