1
I have an external WD 3TB 3.0 USB HDD. I used to have a lot of movies and series stored on it. Recently I tried to clean up what I had on it, and in the process I managed to transfer about 1 TB of movies onto it while removing a lot of series from it.
However I want to transfer the remaining of the series I have on it to another external HDD. At some point yesterday it just randomly started working very slow (between 0 and 750 kb/s). I am trying to get the remaining series moved to my other drive, but when I do it also randomly disconnects which means that I have to start the transfer all over.
I am at a loss of what to do. I have tried performing the same file transfers on another PC and it seems that the problem is the exact same there, which indicates that something is wrong with my drive. How do I fix this?
I googled and some people suggested running a WD Data Lifeguard, but when I try to do that the drive disconnects which results in it not showing up in the results. Furthermore I found some suggestions pointing towards doing a firmware update, so I will try to do that for now and keep you posted.
The drive shows up in device manager but not "My Computer" anymore. EDIT: It suddenly shows up again
Hopefully someone else has a better idea of what I can do to save my drive and all my content. Thanks!
EDIT:
The firmware update was successful and it did decrease the problem a little bit as the drive doesn't seem to disconnect as much as before now. I see a better performance now (355 kb/s - 1.8 mb/s), however it still seems like the drive is disconnecting occasionally or stops the transfer for a few seconds. It is an improvement but it seems like my drive is struggling to perform better, which is should be very able to.
As it seems to be able to maintain a connection I am now doing a chkdsk /r
on the drive hoping that will tell me what the problem is. If that doesn't resolve anything I will try to perform a WD Data Lifeguard
again.
EDIT!
I wrote to WD Technical Support and got a response. For them to perform an RMA I had to contact one of their partners in my country to do a data recovery and take a screenshot of my DLGDIAG. Once the partner who would do the data recovery contacted WD I would get a new external drive as my warranty was not void.
I left my drive without power for a few days between writing to WD and getting a response and once I tried to connect it, it seemed to work like a charm, but that happiness was short lived. I managed to extract a few episodes and then it was all to hell again. I guess I will reply the lady from WD with the screenshot and contact their partner and hopefully get a proper RMA going. I do however think I will extract as much as possible before sending anything anywhere.
Possible hard disk failure. Check your hard drives for SMART errors How can I read my hard drive's SMART status in Windows 7?, and What is the easiest method of checking SMART status for your hard drive?. Report back with the results.
– DavidPostill – 2017-06-17T16:05:23.7671I would back up your data to another hard drive before running any more software or utilities. – Moab – 2017-06-17T16:42:19.357
The Data Lifeguard seemed to not be able to finish due to
too many bad sectors
which I don't really knows what means. Any suggestions? – Zeliax – 2017-06-18T09:02:05.433