1
I'm using a Debian Jessie on a Sony Vaio VPCEB3M1E. Some information about my wireless card:
:~$ sudo ifconfig
wlan0 IEEE 802.11bgn ESSID:"********"
Mode:Managed Frequency:2.412 GHz Access Point: C0:25:06:F1:0B:F3
Bit Rate=39 Mb/s Tx-Power=14 dBm
Retry short limit:7 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality=48/70 Signal level=-62 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:8 Missed beacon:0
:~$ lspci | grep -i wireless
02:00.0 Network controller: Qualcomm Atheros AR9285 Wireless Network Adapter (PCI-Express) (rev 01)
I'm trying to manually adjust the channel and maybe the TX power (currently it's at 14dBm) my adapter uses for transmitting information to the router. So first of all I did a check to see which channels it provides and which I'm currently running (yes, the information is also displayed using sudo ifconfig
;)):
:~$ sudo iwlist wlan0 channel
wlan0 13 channels in total; available frequencies :
Channel 01 : 2.412 GHz
Channel 02 : 2.417 GHz
Channel 03 : 2.422 GHz
Channel 04 : 2.427 GHz
Channel 05 : 2.432 GHz
Channel 06 : 2.437 GHz
Channel 07 : 2.442 GHz
Channel 08 : 2.447 GHz
Channel 09 : 2.452 GHz
Channel 10 : 2.457 GHz
Channel 11 : 2.462 GHz
Channel 12 : 2.467 GHz
Channel 13 : 2.472 GHz
Current Frequency:2.412 GHz (Channel 1)
Next thing I did was to shutdown the interface:
:~$ sudo ifconig wlan0 down
Running sudo ifconfig
showed me only my Virtualbox adapter along with eth0
for my Ethernet. So I thought that the interface is really down. However
:~$ sudo iwconfig wlan0 channel 11
returned
Error for wireless request "Set Frequency" (8B04) :
SET failed on device wlan0 ; Device or resource busy.
I've tried also using sudo ip link set wlan0 down
but still same error.
I've read that on the Internet that this might be to a running ifplugd
which blocks the interface. However upon executing
:~$ sudo service ifplugd stop
I got that no such service is running.
I know that I usually have to wait for some short period of time after executing the command for shutting down an interface however even after 10 minutes of waiting nothing changes and the error still occurs.
Am I doing something wrong here?
PS: I'm actually pretty surprised that the card supports the 802.11n
. I always thought it supported only up to 802.11g
and had some really naughty thoughts about the people at Sony.