Server Fault Stack Exchange
Server Fault Stack Exchange

Questions tagged [vyatta]

Vyatta is an Open Source routing company

Vyatta is an Open Source routing company. They offer a software license to run on your own hardware or an appliance model.

59 questions
1
vote
0 answers

Domain-based instead of IP addresses load balancing in Vyatta

Currently my company has 6 Internet lines (1 Lease line and 5 fiber lines). Only the lease line (eth1) has the static IP address. So, if I want to give users access to secured site (That check IP addresses e.g. Apple Distinguish Educators login), I…
Trinh Nguyen
  • 113
  • 6
1
vote
0 answers

Vyatta Nat Rule Help Translating From Cisco ASA Rule

I'm fairly new to Vyatta and need advice on how to translate the following rule example from a Cisco ASA to the Vyatta. static (dmz2,outside) 192.168.254.0 192.168.254.0 netmask/24 How do I create this NAT rule on the Vyatta?
Rick
  • 203
  • 2
  • 9
1
vote
1 answer

Vyatta and DNS Rewrite (aka hairpin or doctoring)

I'm trying to make my public IP reachable also from inside LAN. I know that it's better to spilt DNS in order to have an internal zone that solves hosts with internal IP, but for a lot of reasons this is not applicable to my environment. I have a…
Fabio
  • 55
  • 1
  • 6
1
vote
0 answers

Issues Migrating from Vyatta 6.3 to VyOS

Finally getting around to migrating an old router from Vyatta 6.3 to VyOS and am having some issues. Due to the incompatibility of 6.3, the VyOS configuration was rewritten while referencing the old VC config.boot and the VyOS example. The IPv6…
Brad
  • 11
  • 2
1
vote
0 answers

Massively large number of packets dropped by interface

I have a virtual machine on ESXi 5 acting as a firewall for a PBX, it is running vyatta. When I run tcpdump on any interface, I get some ridiculous numbers! e.g. 4 packets captured 402 packets received by filter 210 packets dropped by…
metacom
  • 196
  • 6
1
vote
0 answers

Vyatta Remote Access VPN firewall (PPTP)

I am using Vyatta Remote Access VPN (PPTP) and NAT for proxy. When pc-A and pc-B are connected to VPN, pc-A ipaddress is 192.168.10.10 and pc-B is…
hiroo
  • 143
  • 1
  • 5
1
vote
2 answers

What do transmit errors on Linux IPsec virtual tunnel interfaces indicate?

Our monitoring system is indicating transmit errors on the IPsec VTIs on our Vyatta Core routers when they are under high load. They only appear fairly occasionally, and don't appear to seriously impact performance (we're getting pretty close to…
Paul Gear
  • 3,938
  • 15
  • 36
1
vote
0 answers

Issue Routing along IPSEC VPN

I am struggling to get two different subnets routing along a IPSec tunnel. The tunnel is between a Vyatta (6.5) and a Juniper firewall. The tunnel was initially created to route between a subnet in our office behind the Vyatta (10.150.0.0/24) to a…
boburob
  • 1,174
  • 8
  • 23
1
vote
1 answer

Isolating Internet-accessible internal hosts from each other

I'm a sysadmin in a small company, and have what I would describe as a moderate understanding of networking. I'm trying to create a situation in which a number of internal hosts are accessible over RDP from the Internet, but cannot communicate with…
Martin
  • 65
  • 1
  • 4
1
vote
1 answer

Vyatta: how do I view up fixed DHCP leases settings?

I'd like to know how could I get the MAC-IP DHCP associations. I know that there is show dhcp leases but it only shows information about the active leases.
mariosangiorgio
  • 127
  • 2
  • 7
1
vote
1 answer

Linux/Vyatta failover with GRE and OSPF/BGP

I have strange problem with routing failover in scenario: I'm trying do this failover via ospf or bgp, in both happens the same strange behavior with tunnels: For 192.7.0.0 TUN providing default route to R1 - main site (we need all traffic). …
orzeh
  • 11
  • 6
1
vote
1 answer

Disable Certificate Revocation in vyatta ipsec vpn

I have a problem where the VPN on a road warrior configuration. our windows hosts work fine. our mac's don't work so well. Errors from StrongSwan: ocsp status is stale or not in cache crl not found certificate status unknown issuer cacert not…
BeStRaFe
  • 280
  • 1
  • 9
1
vote
1 answer

Vyatta Proxy Setup

So I am currently migrating our office away from the current proxy (Squid running in Windows on our Mail server...I did not set it up...) to a new one, Squid running on Vyatta. So far I have everything setup and working perfectly, however im having…
boburob
  • 1,174
  • 8
  • 23
1
vote
3 answers

Broadcast storm - how to identify the source?

I had two situations this week where my uplink provider had to disable our link because their router identified a broadcast storm. Unfortunately, they can't provide more information about the source of the problem. What is the best way to identify…
Fernando
  • 1,129
  • 6
  • 23
  • 32
1
vote
1 answer

Why won't vyatta allow SMTP through my firewall?

I am setting up a vyatta router on VMware ESXi, But I see to have hit a major snag, I could not get my firewall and NAT to work correctly. I am not sure what was wrong with NAT but it "seems" to be working now. But the firewall is not allowing…
ianc1215
  • 1,965
  • 7
  • 34
  • 55
1
2
3 4