This is a small teardown guide because i had to change the mouse click thingy thing.

First we will remove the rubber rival mark.

Now lets remove the sensor, we will need to do this to remove the bottom of the mouse.

Now we need to remove the feet of it and remove the screw and then from here we pop off the top. Now just pry down the words and it also should pop off.

Now lets remove all the screws from here and store them in a good and safe spot and take out the small connector at the wheel.

On the second photo we will have to pop out the small board.

Before we flip the PCI board around you will need to take out the screws from the small vibrator.

Now with all the screw's removed from the larger board, we can flip it upside down to see the small ricer cable.

Now you can remove all the screws that you see on the smaller board.